Simulink Control Design™ - MathWorks

To verify that all openings have been removed, display the contents of sllin, and examine the information about the interface op ...

You can add permanent openings to an slLinearizer or slTuner interface, s, when you create the interface or by using the addOpen ...

removeAllPoints Remove all points from list of analysis points in slLinearizer or slTuner interface Syntax removeAllPoints(s) De ...

No permanent openings. Use the addOpening command to add new permanent openings. Properties with dot notation get/set access: Pa ...

To view all the analysis points of s, type s at the command prompt to display the interface contents. For each analysis point of ...

removeOpening Remove opening from list of permanent loop openings in slLinearizer or slTuner interface Syntax removeOpening(s,op ...

Remove Multiple Openings Using Signal Names Create an slLinearizer interface for the scdcascade model. sllin = slLinearizer('scd ...

slLinearizer linearization interface for "scdcascade": No analysis points. Use the addPoint command to add new points. 3 Permane ...

'y2m', 'y1m', and 'u1' are the names of signals in the scdcascade model. The addOpening command adds these signals to the list o ...

Input Arguments s — Interface to Simulink model slLinearizer interface | slTuner interface Interface to a Simulink model, specif ...

Definitions Permanent Openings Permanent openings, used by the slLinearizer and slTuner interfaces, identify locations within a ...

removePoint Remove point from list of analysis points in slLinearizer or slTuner interface Syntax removePoint(s,pt) Description ...

sllin = slLinearizer('scdcascade',{'r','e1','y1m'}); Remove the y1m and e1 points from the interface. removePoint(sllin,{'y1m',' ...

OperatingPoints : [] (model initial condition will be used.) BlockSubstitutions : [] Options : [1x1 linearize.LinearizeOptions] ...

No permanent openings. Use the addOpening command to add new permanent openings. Properties with dot notation get/set access: Pa ...

For example, pt = 'y1m'. Cell array of character vectors or string array — Specifies multiple analysis point names. For example ...

For more information about how you can use analysis points, see “Mark Signals of Interest for Control System Analysis and Design ...

addBlock Add block to list of tuned blocks for slTuner interface Syntax addBlock(st,blk) Description addBlock(st,blk) adds the b ...

Create an slTuner interface for the Simulink model, and add a block to the list of tuned blocks of the interface. st = slTuner(m ...

SubSystem or S-Function blocks by specifying an equivalent tunable linear model (Control System Toolbox). Use tuning commands su ...