Simulink Control Design™ - MathWorks

Enable zero-crossing detection Enable zero-crossing detection to ensure that the software computes the linear system characteris ...

On Compute linear system characteristics at the exact snapshot time or exact time when a trigger signal is detected. This settin ...

Command-Line Information Parameter: UseExactDelayModel Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot L ...

Positive finite value. Use to compute: A discrete-time linear system from a continuous-time system. A discrete-time linear syst ...

Tustin (bilinear) Bilinear (Tustin) approximation without frequency prewarping. The software rounds off fractional time delays t ...

enables Prewarp frequency (rad/s) on page 16-18. Command-Line Information Parameter: RateConversionMethod Type: character vector ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

Value: 'on' | 'off' Default: 'off' See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verif ...

Command-Line Information Parameter: UseBusSignalLabels Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot L ...

Tips Clearing this parameter disables the upper magnitude bounds and the software stops checking that the bounds are satisfied ...

Settings Default: [] for Bode Plot block [10 100] for Check Bode Characteristics block Must be specified as start and end freque ...

“Verify Model at Default Simulation Snapshot Time” on page 14-6 Magnitudes (dB) Magnitude values for one or more upper magnitude ...

Command-Line Information Parameter: UpperBoundMagnitudes Type: character vector Value: [] | [-20 -20] | finite number | matrix o ...

Tips Clearing this parameter disables the lower magnitude bound and the software stops checking that the bounds are satisfied d ...

Settings Default: [] for Bode Plot block [0.1 1] for Check Bode Characteristics block Must be specified as start and end frequen ...

“Verify Model at Default Simulation Snapshot Time” on page 14-6 Magnitudes (dB) Magnitude values for one or more lower magnitude ...

You must click Update Block before simulating the model. Command-Line Information Parameter: LowerBoundMagnitudes Type: characte ...

For more information about data logging in Simulink, see “Export Simulation Data” (Simulink) and the Simulink.SimulationOutput r ...

If the Simulink model is configured to save simulation output as a single object, the data structure is a field in the Simulink ...

Settings Default: Off On Save the operating points. Off Do not save the operating points. Dependencies Save data to workspace on ...