Simulink Control Design™ - MathWorks

The Trim progress viewer shows the optimization progress and that the optimization algorithm terminated successfully. The (Maxim ...

To evaluate whether the resulting operating point values meet the specifications, in the Linear Analysis Workspace, double-click ...

Constrain State Derivatives When you trim your model to meet state specification, you can also constrain the derivatives of stat ...

To compute the operating point, click Start trimming. In the Linear Analysis Tool, in the Linear Analysis Workspace, double-clic ...

After trimming your model, you can: Linearize your model at the resulting operating point. For more information, see “Linearize ...

Validate Operating Point Against Specifications When you compute an operating point based on input, output, or state specificati ...

To trim the model, on the Specification tab, click Trim. The software generates an operating point report and, in the correspond ...

The optimization search could not find an operating point that satisfies the specifications. As highlighted in Steady State Mana ...

For this model, specifying the second position state to be at steady state overconstrains the system, making a steady-state solu ...

You can also validate an existing operating point against a set of specifications. For example, to check if the model initial co ...

The software creates an operating point report and opens a corresponding report3 tab. The model initial conditions do not satisf ...

Validate Operating Point in Linear Analysis Tool When you compute an operating point using Linear Analysis Tool, the software do ...

validate your operating point against the specifications, you must check whether the operating point values satisfy the constrai ...

(4.) scdairframeTRIM/Airframe Model/EOM/ Equations of Motion (Body Axes)/q x: 0 dx: 31.2 (0) Inputs: ---------- (1.) scdairframe ...

“Compute Operating Points from Specifications Using Linear Analysis Tool” on page 1-41 See Also ...

Initialize Steady-State Operating Point Search Using Simulation Snapshot If you know the approximate time when the model reaches ...

(^5) To take a snapshot of the system at the specified time, click Take Snapshots. The snapshot, op1, appears in the Data Browse ...

(^8) To find the optimized operating point using the states at t = 10 as the initial values, on the Specification tab, click Tri ...

(^2) In the Simulink Editor, select Analysis > Control Design > Linear Analysis. (^3) In the Linear Analysis Tool, in the ...

In the Trim the model dialog box, the displayed state values update to reflect the imported values. 1 Steady-State Operating Poi ...