Simulink Control Design™ - MathWorks

G_ineq - Gradient array for the inequality constraints G_eq - Gradient array for the equality constraints Each column of G_ine ...

end Because the objective function in this example is piecewise differentiable, the value of G depends on the value of the press ...

[op4,rpt4] = findop(mdl,opspec,opt); op4.States (1.) scdTanks/Inertia x: 0 (2.) scdTanks/Tank1 x: 15 (3.) scdTanks/Tank2 x: 15 ( ...

More About “Compute Steady-State Operating Points” on page 1-6 1 Steady-State Operating Points ...

Batch Compute Steady-State Operating Points for Multiple Specifications This example shows how to find operating points for mult ...

opspec(i).Outputs(1).Known = true; end Specify different known output values for each operating point specification. opspec(1).O ...

Operating point search report for the Model scdspeed. (Time-Varying Components Evaluated at time t=0) Operating point specifica ...

---------- (1.) scdspeed/rad//s to rpm y: 2.5e+03 (2.5e+03) ops is a vector of operating points for the scdspeed model that corr ...

Batch Compute Steady-State Operating Points for Parameter Variation Block parameters configure a Simulink model in several ways. ...

The following table lists some common ways of specifying parameter samples. Parameter Sample-Space Type How to Specify the Param ...

Here, you vary the values of three parameters, a, b, and c. The samples form a 3-by-4-by-5 grid. op is an array with same dimens ...

parameters. Corresponding array entries for all the parameters, also referred to as a parameter grid points, must map to a speci ...

params(1).Name = 'a'; params(1).Value = A; params(2).Name = 'b'; params(2).Value = B; In general, to specify a full grid for N p ...

Open the Simulink model. sys = 'watertank'; open_system(sys) Vary parameters A and b within 10% of their nominal values. Specify ...

(1.) watertank/PID Controller/Integrator/Continuous/Integrator spec: dx = 0, initial guess: 0 (2.) watertank/Water-Tank System/H ...

Inputs: None ---------- Batch Trim Model at Known States Derived from Parameter Values This example shows how to batch trim a mo ...

nA = 6; % number of alpha values nV = 4; % number of V values alphaRange = linspace(-20,20,nA)*pi/180; vRange = linspace(700,140 ...

opt = findopOptions('DisplayReport','off'); op = findop(sys,opspec,params,opt); findop trims the model for each parameter combin ...

Batch Compute Steady-State Operating Points Reusing Generated MATLAB Code This example shows how to batch-compute steady-state o ...

(^4) In the spec1 document, in the Known column, select the magball/Magnetic Ball Plant/height state. (^5) Generate the trimming ...