Simulink Control Design™ - MathWorks

% - Default model initial conditions are used to initialize optimization. opspec.States(5).Known = true; %% Create the options o ...

Find Operating Points at Simulation Snapshots You can find a steady-state operating point using a model simulation. The resultin ...

To open the Steady State Manager, in the Simulink model window, select Analysis > Control Design > Steady State Manager. T ...

Compute Operating Points at Simulation Snapshots Using Linear Analysis Tool You can find an operating point at specified simulat ...

Take simulation snapshots at 1 and 10 time units. In the Enter snapshot times to linearize dialog box, in the Simulation snapsho ...

Find Operating Points at Simulation Snapshots at Command Line This example shows how to compute a steady-state operating point a ...

(1.) magball/Controller/PID Controller/Filter/Cont. Filter/Filter x: 5.76e-06 (2.) magball/Controller/PID Controller/Integrator/ ...

Computing Operating Point Snapshots at Triggered Events This example shows how to generate operating points using triggered snap ...

The output settling time events are then fed to an Operating Point Snapshot block. In this example, the block creates operating ...

The first operating point is near the 2500 rpm (261.8 rad/s) settling condition. op(1) Operating point for the Model scdspeedtri ...

op(3) Operating point for the Model scdspeedtrigger. (Time-Varying Components Evaluated at time t=48.2688) States: (1.) scdspeed ...

1 Steady-State Operating Points ...

Simulate Simulink Model at Specific Operating Point This example shows how to initialize a model at a specific operating point f ...

On the Operating Point tab, click Set Initial Conditions. The software sets the initial conditions of the model to match the inp ...

If you computed multiple operating points using a simulation snapshot, select an operating point from the Select Operating Point ...

In the Initialize Model dialog box, specify a Variable Name for the operating point object. Alternatively, you can use the defau ...

Handle Blocks with Internal State Representation Operating Point Object Excludes Blocks with Internal States The operating point ...

where sys is the model name. This command also returns the number of occurrences of each block. Configuring Blocks with Internal ...

For other blocks with internal states, determine whether the output of the block impacts the state derivatives or desired output ...

Synchronize Simulink Model Changes with Operating Point Specifications Modifying your Simulink model can change, add, or remove ...