You must click Update Block before simulating the model.Command-Line Information
Parameter: CLPeakGain
Type: character vector
Value: [] | positive or negative number | cell array of positive or negative numbers. Must
be specified inside single quotes ('').
Default: '[]'
See Also
Plot Linear Characteristics of Simulink Models During Simulation on page 2-82
“Verify Model at Default Simulation Snapshot Time” on page 14-6
Include open-loop gain-phase bound in assertion
Check that the Nichols response satisfies open-loop gain and phase bounds, specified in
Open-loop phases (deg) on page 16-208 and Open-loop gains (dB) on page 16-209,
during simulation. The software displays a warning if the Nichols response violates the
bounds.
This parameter is used for assertion only if Enable assertion on page 16-215 in the
Assertion tab is selected.
You can specify multiple gain and phase bounds on the linear systems computed during
simulation. The bounds also appear on the Nichols plot. If you clear Enable assertion,
the bounds are not used for assertion but continue to appear on the plot.
Settings
Default: Off
On
Check if the Nichols response satisfies the specified open-loop gain and phase
bounds, during simulation.Off
Do not check if the Nichols response satisfies the specified open-loop gain and phase
bounds, during simulation.Nichols Plot