Tips
- Clearing this parameter disables the settling time bounds and the software stops
checking that the bounds are satisfied during simulation. The bounds are also greyed
out on the plot. - If you also specify other bounds, such as percent overshoot on page 16-264, damping
ratio on page 16-268 or natural frequency on page 16-271, but want to exclude the
settling time bound from assertion, clear this parameter. - To only view the bounds on the plot, clear Enable assertion.
Command-Line Information
Parameter: EnableSettlingTime
Type: character vector
Value: 'on' | 'off'
Default: 'off' for Pole-Zero Plot block, 'on' for Check Pole-Zero Characteristics block.
See Also
Plot Linear Characteristics of Simulink Models During Simulation on page 2-82
“Verify Model at Default Simulation Snapshot Time” on page 14-6
Settling time (sec) <=
Settling time, in seconds, of the second-order system.
Pole-Zero Plot