This parameter is used for assertion only if Enable assertion on page 16-277 in the
Assertion tab is selected.
You can specify multiple percent overshoot bounds on the linear system. The bounds also
appear on the pole-zero plot. If you clear Enable assertion, the bounds are not used for
assertion but continues to appear on the plot.
Settings
Default:
Off for Pole-Zero Plot block.
On for Check Pole-Zero Characteristics block.
On
Check that each pole lies in the region defined by the percent overshoot bound,
during simulation.Off
Do not check that each pole lies in the region defined by the percent overshoot bound,
during simulation.Tips
- Clearing this parameter disables the percent overshoot bounds and the software stops
checking that the bounds are satisfied during simulation. The bounds are also greyed
out on the plot.
Pole-Zero Plot