SolidWorks 2010 Bible
Chapter 8: Patterning and Mirroring ........................................................................................... ...
Part II: Building Intelligence into Your Parts FIGURE 8.2 Comparing rebuild times of a fully defined sketch to a completely unde ...
Chapter 8: Patterning and Mirroring . . . . . . . . . . . . . . . . . . . . . . . . . . . FIGURE 8.3 The Linear Pattern Propert ...
Part II: Building Intelligence into Your Parts Mirroring in a Sketch Mirroring in a sketch is a completely different matter from ...
Chapter 8: Patterning and Mirroring FIGURE 8.5 The Dynamic Mirror centerline with hatch marks Sketch patterns are also unavailab ...
Part II: Building Intelligence into Your Parts FIGURE 8.6 A geometry pattern test Geometry pattern off — Parametrics are pattern ...
Chapter 8: Patterning and Mirroring There are both advantages and disadvantages to mirroring and patterning bodies instead of fe ...
Part II: Building Intelligence into Your Parts FIGURE 8.8 A circular pattern using the Pattern Faces option FIGURE 8.9 Patternin ...
Chapter 8: Patterning and Mirroring Patterning Fillets You may hear people argue that you cannot pattern fillets. This is only p ...
Part II: Building Intelligence into Your Parts FIGURE 8.10 Using the default two-direction pattern and the Pattern Seed Only opt ...
Chapter 8: Patterning and Mirroring FIGURE 8.12 Using the Vary Sketch option On the CD-ROM To better understand how this feature ...
Part II: Building Intelligence into Your Parts Circular Pattern The Circular Pattern feature requires a circular edge or sketch, ...
Chapter 8: Patterning and Mirroring For an entire sketch to be used as a curve, the sketch must not have any sharp corners — all ...
Part II: Building Intelligence into Your Parts FIGURE 8.15 Using the Transform Curve and Tangent to Curve options Instead of an ...
Chapter 8: Patterning and Mirroring FIGURE 8.16 Using a 3D Curve Driven Pattern FIGURE 8.17 Using Direction 2 with a Curve Drive ...
Part II: Building Intelligence into Your Parts FIGURE 8.18 Using a Sketch Driven Pattern FIGURE 8.19 Using the Selected Point op ...
Chapter 8: Patterning and Mirroring Table Driven Pattern A Table Driven Pattern drives a set of feature locations, most commonly ...
Part II: Building Intelligence into Your Parts Fill Pattern The Fill Pattern feature fills a face or area enclosed by a sketch w ...
Chapter 8: Patterning and Mirroring The Pattern Layout panel enables you to control spacing and other geometrical aspects of the ...
Part II: Building Intelligence into Your Parts FIGURE 8.22 Cosmetic Pattern options in the RealView tab of the Task Manager Mirr ...
«
14
15
16
17
18
19
20
21
22
23
»
Free download pdf