SolidWorks 2010 Bible
Chapter 11: Editing and Evaluation FIGURE 11.9 Contact, tangency, and curvature continuity Original surfaces Original faces with ...
Part II: Building Intelligence into Your Parts FIGURE 11.10 Curvature display Deviation analysis Deviation Analysis measures how ...
Chapter 11: Editing and Evaluation Tangent Edges as Phantom Using the Tangent Edges as Phantom setting is an easy way to evaluat ...
Part II: Building Intelligence into Your Parts FIGURE 11.13 Using Geometry Analysis to find typical problem spots These specific ...
Chapter 11: Editing and Evaluation FIGURE 11.14 Feature Statistics helps you analyze rebuild times for features. Curvature Comb ...
Part II: Building Intelligence into Your Parts Cross-Reference The Curvature Comb is discussed in depth in the SolidWorks Surfac ...
Chapter 11: Editing and Evaluation Welcome to SolidWorks SimulationXpress When you start SimulationXpress, an image welcomes you ...
Part II: Building Intelligence into Your Parts On this part, I have used the Split Line feature to split out areas of the bottom ...
Chapter 11: Editing and Evaluation FIGURE 11.18 Applying loads to the model in SimulationXpress Selecting a Material The third s ...
Part II: Building Intelligence into Your Parts Tip My experience with the early versions of SimulationXpress in SolidWorks 2010 ...
Chapter 11: Editing and Evaluation Each of these can be animated. The deformation shown by the model is exaggerated by a deforma ...
Part II: Building Intelligence into Your Parts FIGURE 11.22 Accessing the results and inputs for the study in the lower panel of ...
Chapter 11: Editing and Evaluation FIGURE 11.23 Entering a range of sizes for the optimized feature Tutorial: Making Use of Edit ...
Part II: Building Intelligence into Your Parts FIGURE 11.24 Deviation analysis of an existing part Select RMB then select tangen ...
Chapter 11: Editing and Evaluation Try to draw a horizontal line from the outer end of the spiral. You will notice that you can ...
Part II: Building Intelligence into Your Parts Caution Do not exit the Fit Spline by pressing the Enter key as you do with other ...
Chapter 11: Editing and Evaluation FIGURE 11.28 Sketch3 in its new location One of the goals of these edits is to smooth out th ...
Part II: Building Intelligence into Your Parts FIGURE 11.29 Positioning the connectors Position connector dots in approximately ...
Chapter 11: Editing and Evaluation FIGURE 11.30 Repairing Fillet5 Make selections to fillet edges Edit the Shell feature and se ...
Part II: Building Intelligence into Your Parts At this point, you should notice that something does not look right. This is bec ...
«
19
20
21
22
23
24
25
26
27
28
»
Free download pdf