Chapter 29: Using SolidWorks Sheet Metal Tools
FIGURE 29.17
The Start/End Offset settings for a Miter Flange
End Offset
Start Offset
Sketch for
Miter Flange
FIGURE 29.18
The Hem PropertyManager and a sample hem
One of the limitations to keep in mind with regard to hems is that SolidWorks cannot fold over a
part so that the faces touch perfectly line on line. Doing this would cause the two sections of the
part to merge into a larger piece, thus removing the coincident faces. SolidWorks, computers, and
mathematics in general do not always handle the number zero very well. In reality, you can often
see light through these hems, and so a perfectly flush hem may not be as accurate as it seems.