RX8--Transmission (Manual & Auto)

DTC P0720 DTC P0720 Vehicle speed sensor (VSS) malfunction (open circuit/short to ground) DETECTION CONDITION While driving in ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

INSPECT VSS POWER SUPPLY CIRCUIT FOR OPEN CIRCUIT Turn the ignition switch to the ON position (engine off). Inspect the voltage ...

Inspect the VSS. (See VEHICLE SPEED SENSOR (VSS) INSPECTION .) Is the VSS normal? No Replace the VSS, then go to the next st ...

DTC P0731 DTC P0731 Gear 1 incorrect (incorrect gear ratio detected) DETECTION CONDITION TCM monitors rotation ratio of the par ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

Start the engine. Measure each line pressure. Specification D, M range o Idle: 320450 kPa {3.34.6 kgf/cm^2 , 46 65 ...

Yes Go to Step 10. 8 INSPECT FREQUENCY OF TURBINE SENSOR WHEN DRIVING VEHICLE Turn the ignition switch to the LOCK position. Co ...

Make sure to reconnect all disconnected connectors. Clear DTC using the WDS or equivalent. Start the engine. Warm up AT. Drive ...

DTC P0732 DTC P0732 Gear 2 incorrect (incorrect gear ratio detected) DETECTION CONDITION TCM monitors rotation ratio of the par ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

Start the engine. Measure each line pressure. Specification D, M range o Idle: 320450 kPa {3.34.6 kgf/cm^2 , 46 65 ...

Yes Go to Step 10. 8 INSPECT FREQUENCY OF TURBINE SENSOR WHEN DRIVING VEHICLE Turn the ignition switch to the LOCK position. Co ...

Make sure to reconnect all disconnected connectors. Clear DTC using the WDS or equivalent. Start the engine. Warm up AT. Drive ...

DTC P0733 DTC P0733 Gear 3 incorrect (incorrect gear ratio detected) DETECTION CONDITION TCM monitors rotation ratio of the par ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

Start the engine. Measure each line pressure. Specification D, M range o Idle: 320450 kPa {3.34.6 kgf/cm^2 , 46 65 ...

Yes Go to Step 10. 8 INSPECT FREQUENCY OF TURBINE SENSOR WHEN DRIVING VEHICLE Turn the ignition switch to the LOCK position. Co ...

Make sure to reconnect all disconnected connectors. Clear DTC using the WDS or equivalent. Start the engine. Warm up AT. Drive ...

DTC P0734 DTC P0734 Gear 4 incorrect (incorrect gear ratio detected) DETECTION CONDITION TCM monitors rotation ratio of the par ...