Masterclass
ank you so much
Make sure to keep the outside part of the
mask, we want to protect the background,
and add colour to the images, which is the opposite to usualTop tip
You will need
● white 14.5x10.5cm
card blank
● black & white cardstock
● Woodware Pebble Pops & I
Saw This... stamp sets
● Altenew Flowing Drops
6x6” stencil
● white gel pen
● black fine-line pen
● Picked Raspberry, Abandoned
Coral, Fossilized Amber,
Seedless Preserves &
Peacock Feathers Ragner
Tim Holtz Distress Oxide Ink
● VersaMark inkpad
● silverCosmic Shimmer
Detail embossing powder
● Gloss Simply White Tonic
Studios Nuvo Crystal Drops
● Nocturne VersaFine
Clair inkpad
● ink-blending tool
● heat tool
Simply make
1 Ink-blend an ombré of colours
across a piece of black
cardstock, spray the stencil
with water and ip it over
onto the the inked panel –
For you
You will need
● white & black cardstock
● white 10.5x13.5cm
card blank
● masking paper
● Woodware Thank you
Flowers stamp set
● Picked Raspberry,
Abandoned Coral,
Fossilized Amber,
Seedless Preserves &
Peacock Feathers
Ranger Tim Holtz
Distress Oxide Ink
● VersaMark inkpad
● gold Cosmic Shimmer
Detail embossing powder
● Gloss Simply White Tonic
Studios Nuvo Crystal Drops
● white & gold gel pens
● Nocturne VersaFine
Clair inkpad
● heat tool
● ink-blending tool
● manual die-cutting
machine
● Sizzix Thinlits Tim Holtz
Mixed Media dies
● stamping platformSimply make
1 Follow the basic steps
from the advanced step-
by-step guide on page
54, this time creating
the negative mask for
the three pod owers.
2 Once you’ve removed
the mask, add a little
extra ink blending
around the stamen area
of two of the owers.
There might be a harsh
line there from the
mask, so this will soften
it a bit.
3 Use one of the Mixed
Media dies to cut detail
into the black card
panel, this will help the
card look lighter, as the
white card blank will
show through.
4 Add a stamped
sentiment and white
gel pen details; you can
even colour the stems
with a gold gel pen too.this will give you an oxidised
pattern that’s the negative of
the stencil design.
2 Once dry, trim the panel into
three separate pieces that
are slightly wider than thestamps you’re using, and
keeping the ombré of colour.
3 Heat-emboss the images
using silver embossing
powder onto the three inked
panels. Then add extradetails with black and
white pens.
4 Finish the card with a
stamped sentiment and
Gloss Simply White Nuvo
Drops to add extra interest.