TOYOTA PREVIA 91-97 REPAIR MANUAL

BODY AND TRIM 10-11

Fig. 28 Locate the wiring harness for the power mirror

Fig. 29 Remove these two mirror retaining bolts

Fig. 30 Pull the wiring for the mirror through the opening

3. Depending on the style of mirror, there may be concealment plugs or
   other minor parts under the delta cover—remove them.


4. Support the mirror housing from the outside and remove the bolts or
   nuts holding the mirror to the door.


5. Remove the mirror assembly.
   To install:


6. Fit the mirror to the door and install the nuts and bolts to hold it. Pay
   particular attention to the placement and alignment of any gaskets or weath-
   erstrips around the mirror; serious wind noises may result from careless
   work.


7. Install any concealment plugs, dust boots or seals which were
   removed.


8. Install the delta cover and install the adjustment knob, if it was
   removed.


9. Cycle the mirror several times to make sure that it works properly.

Antenna

REPLACEMENT

Some antenna masts are attached to the side of the windshield pillar on

the drivers side. Simply unscrew the two plastic holders and proceed with

cable removal, there will be on some models a rear antenna incorporated in

the rear windshield, this can only be replaced with the glass.

Disconnect the antenna cable at the radio by pulling it straight out of the

set. Depending on access, this may require loosening the radio and pulling

it out of the dash. Working under the instrument panel, disengage the cable

from its retainers.

~0n some models, it may be necessary to remove the instrument

panel pad to get at the cable.

Outside, unsnap the cap from the antenna base. Remove the screw(s)

and lift off the antenna base, pulling the cable with it, carefully. When rein-

stalling, make certain the antenna mount area is clean and free of rust and

dirt. The antenna must make a proper ground contact through its base to

work properly. Install the screws and route the cable into the interior. Make

certain the cable is retained in the clips, etc. Attach the cable to the radio;

reinstall the radio if it was removed

Fenders

REMOVAL & INSTALLATION

» See Figure 31

1. Remove the inner liner from the fender to be removed.

** WARNING

Be careful of the SRS modules located in the wheel wells, these

must not be damaged or bumped during removal of the liner or

fender.

2. Remove of disconnect all electrical items attached to the fender.


3. If necessary, remove the front bumper assembly.


4. Remove all bolts attaching the fender and the brace to the firewall
   and the radiator/grille panel.


5. Remove the rear attaching bolts through the pillar opening and
   remove the fender from the vehicle.
   To install:


6. Attach the fender to the vehicle with the mounting bolts and tighten
   securely. Make sure the fender is aligned correctly with all other panels.


7. If removed, attach the front bumper.


8. Install and connect all electrical components removed.


9. Attach the inner fender liner.