Power steering--Power steering gear assembly
- Connect the bolts and nuts of left/right control arm
and control arm ball head.
Torque: 142 ± 10 Nxxxxxm
Hint: connect the other side with same method.
Connect left lower control arm to steering knuckle with
bolt and two nuts.
- Connect linking lever assembly of left/right front
stabilizer bar [64000097].
Use socket head wrench (5mm) to fix bolt, then connect sta-
bilizer linking lever with screw cap.
Torque: 74 ± 5 Nxxxxxm
Hint: connect the other side with same method.
- Connect the in-out oil pipe assembly of power steer-
ing gear [64000131].
(a) Connect the in-out oil pipe fixed clamp of power steering
gear with bolt.
Torque: 7.8 Nxxxxxm
(b) Use special tool to connect the in-out oil pipe assembly of
power steering gear.
Torque: 41 Nxxxxxm
Hint:
z Use the torque wrench whose lever length is
345mm.
z Special tool should be parallel with torque wrench,
only this could make practical torque value.
Hint: connect the other side with same method.
- Connect the ball head at the left side of transversal
lever.
(a) Connect the ball head at the left side of transversal lever
with screw cap.
Torque: 49 ± 5 Nxxxxxm
(b) Assemble new cotter pin.
Note: if cotter pin hole could not be aligned , tighten
the screw cap for 60 again.
Hint: connect the other side with same method.
211
Length of lever
