Simulink Control Design™ - MathWorks

You must click Update Block before simulating the model.

Command-Line Information

Parameter: UpperBoundMagnitudes

Type: character vector

Value: [] | [0 0] | finite number | matrix of finite numbers | cell array of matrices with

finite numbers. Must be specified inside single quotes ('').

Default: '[]' for Singular Value Plot block, '[0 0]' for Check Singular Value

Characteristics block.

See Also

Plot Linear Characteristics of Simulink Models During Simulation on page 2-82

“Verify Model at Default Simulation Snapshot Time” on page 14-6

Include lower singular value bound in assertion

Check that the singular values satisfy lower bounds, specified in Frequencies (rad/sec)

on page 16-310 and Magnitude (dB) on page 16-311, during simulation. The software

displays a warning if the singular values violate the lower bound.

This parameter is used for assertion only if Enable assertion on page 16-315 in the

Assertion tab is selected.

You can specify multiple lower singular value bounds on the linear system. The bounds

also appear on the singular value plot. If you clear Enable assertion, the bounds are not

used for assertion but continue to appear on the plot.

Settings

Default: Off

On

Check that the singular value satisfies the specified lower bounds, during simulation.

Off

Do not check that the singular value satisfies the specified lower bounds, during

simulation.

16 Blocks — Alphabetical List