Lesson 7 – Modeling the Truck
Section III – Modeling Complex Parts 7.3 Modeling the Truck
Use Extruded Boss/Base to create the pivot. Use the Draft On/Off option and type 5
degrees. Select Up to Surface for the extrusion and the rotated plane to end the
extrusion. See Figure 7.6.
Click the check mark.
Step 51: Create a dome at
the end of the pivot.
Select the surface at
the end of the pivot
as the sketch
surface.
Click Insert
FeaturesDome.
The distance is 0.20
inch. See Figure 7.7.
Figure 7. 6 – Tapered Extrusion for Pivot
Figure 7. 7 – Pivot Dome