Although this aircraft was kept clean by
its aircrew I wanted to add some subtle
weathering effects. I used Oil Brushers Grey
oil paint to dab along the inside of the wing
and fuselage panels, which I blended using a
wide brush. This added a nice gentle fade to
the leading edge of each panel. I added some
exhaust streaks to the various vents using
Streaking grime and gently blended it. I also
added a few hydraulic leaks and dirty marks to
the ailerons and fl aps.I worked on a few of the other areas in the
meantime. I built up the resin exhaust section
and painted the metal areas using Ammo by
Mig Metal Colours. This was a marked change
from using Alclad as I normally do but I was
sent a set by Ammo to sample. I have to admit
the paint is shiny but not as fi ne or vibrant as
the Alclads I normally use.
Once the paint was dried I added a wash
around the reliefs and drybrushed some
highlights over the raised areas using theAlthough this aircraft was kept clean by
its aircrew I wanted to add some subtle
weathering effects. I used Oil Brushers Grey
oil paint to dab along the inside of the wingI worked on a few of the other areas in the
meantime. I built up the resin exhaust section
and painted the metal areas using Ammo by
Mig Metal Colours. This was a marked changeIssue 155 - http://www.modelairplaneinternational.com 61and fuselage panels, which I blended using a
wide brush. This added a nice gentle fade to
the leading edge of each panel. I added some
exhaust streaks to the various vents using
Streaking grime and gently blended it. I also Streaking grime and gently blended it. I also
added a few hydraulic leaks and dirty marks to
the ailerons and fl aps.Ready for decalsThe undersideDecals added to the forward
fuselagePainting the resin engine area- I used
the Mig Ammo Engine Set for thisAdding the dirt and
a dark wash to the
exhaustUsing Oil Brushers to add the grime
associated with the exhaustFuel tankd painted
XF-19, and a pencil
used to simulate any
chips and dirtBIG CAT.indd 61 04/05/2018 16:34