TOYOTA PREVIA 91-97 REPAIR MANUAL

ENGINE AND ENGINE OVERHAUL 3-25 Front CORRECT WRONG WRONG 90913G55 Fig. 77 Align the insulators at the front correctly Install ...

3-26 ENGINE AND ENGINE OVERHAUL Hole Hole Knock Pin Knock RSn Fig. 81 Aligning the hole with the knock pin when installir insula ...

ENGINE AND ENGINE OVERHAUL 3-27 Uniformly remove the head bolts following the sequence. ••The cylinder head is positioned on t ...

3-28 ENGINE AND ENGINE O'i/ERHAUL Painted Mark Front Fig. 90 Mark the front of the head bolt with paint Painted Mark Fig. 91 Ret ...

ENGINE AND ENGINE OVERHAUL 3-29 No. 2 Cylinder Head Cover flH Fran! Engi Mounting + Non-reusable part Fig. 93 Exploded view of ...

3-30 ENGINE AND ENGINE OVERHAUL Fig. 95 Unbolt and remove the engine wire Relieve the fuel system pressure. * CAUTION Fuel inj ...

ENGINE AND ENGINE OVERHAUL 3-31 Remove the intake manifold. Remove the right side engine mounting. Remove the exhaust manifold ...

3-32 ENGINE AND ENGINE (JVERHAUL Oil Level Sensor- * Engine Cooian Drain Cock Non-reusable part Precoated part Fig. 103 No. 1 oi ...

ENGINE AND ENGINE OVERHAUL 3-33 Do Not Remove Fig. 106 Remove only these twelve bolts not the other three shown Fig. 107 Tight ...

3-34 ENGINE AND ENGINE OVERHAUL Install the oil pressure switch, left engine mount and stay, lighten the left engine mount bolt ...

ENGINE AND ENGINE OVERHAUL 3-35 No.2 Engine Hange 1 Camshaft Timing Gea Dampi LH Front Engine Mounting Crankshaft Pulley Mountin ...

3-36 ENGINE AND ENGINE ClVERHAUL Fig. 116 Unbolt the chain slipper and damper from the timing area Fig. 119 Remove the 2 bolts, ...

ENGINE AND ENGINE OVERHAUL 3-37 SST Fig. 121 Using a driver to install the crankshaft timing gear Fig. 124... then tighten these ...

3-38 ENGINE AND ENGINE OVERHAUL Fig. 126 Tie the timing chain together as shown e. Nm) Install and tighten the three chain case ...

ENGINE AND ENGINE OVERHAUL 3-39 CAUTION Some models covered by this manual may be equipped with a Supplemental Restraint System ...

3- ENGINE AND ENGINE OVERHAUL Fig. 135 Be sure to place the wrench on a portion of the camshaft where it will not be damaged Fig ...

ENGINE AND ENGINE OVERHAUL 3-41 Fig. 139 Set knock pin hole of exhaust camshaft at 5-30 degrees BTDC of camshaft angle Fig. 142 ...

3-42 ENGINE AND ENGINE OVERHAUL Fig. 145 Alternately loosen and remove the bolts on the N >. 4 bearing cap last ^•Remember, t ...

ENGINE AND ENGINE OVERHAUL 3-43 Fig. 150 Uniformly loosen and remove the intake camshaft bear- ing cap bolts Fig. 153 Remove the ...

3-44 ENGINE AND ENGINE CJVERHAUL Fig. 155 Place the intake camshaft at 75-100°BTDC of the camshaft angle on the head Intake % Fi ...