TOYOTA PREVIA 91-97 REPAIR MANUAL

6-34 CHASSIS ELECTRICAL

Fig. 98 Disengage the spring clip which retains one tapere 1 end

of this dome light bulb

4. Position the bulb between the two metal contacts. If the con bets
   have small holes, be sure that the tapered ends of the bulb are situated in
   them.


5. To ensure that the replacement bulb functions properly, activ te the
   applicable switch to illuminate the bulb which was just replaced. If
   replacement light bulb does not illuminate, either it is faulty or (her is a
   problem in the bulb circuit or switch. Correct as necessary.


6. Install the cover lens until its retaining tabs are properly erjbaged

Fog/Driving Lights

REMOVAL & INSTALLATION

» See Figures 99, 100, 101 and 102

p»Make sure both the fog light switch and headlight switch
off.

1. On the left fog light, remove the air inlet duct.

2. Turn the cover counterclockwise, remove it and disconnect tl"
   wiring.

Fig. 99 On the left fog light, remove the air inlet duct to ace

the assembly

re

Fig. 100 Turn the cover counterclockwise, then disconnect the

wiring

Remove Install

Bulb retaining spring

Fig. 101 Release the spring and extract the bulb

This side up

. 102 The triangle must face upwards during installation