Manual of Purpose-Made Woodworking Joinery
72 Making doors and doorframes Scribed- joint details Figures 5.1(e) to (n): Scribing and fitting edge- moulded components has a ...
Panelled doors 73 machine- made joints and scribes (indicated with broken lines in Figures 5.1(a) and (b) above). Figure 5.1(e) ...
74 Making doors and doorframes Figure 5.1 (l) Machined ovolo scribes continuous across each shoulder. The 12mm haunch projection ...
Panelled doors 75 Figure 5.1 (n) The 1.5 × 2.5mm slivers of mould-edge have been pared off in the area of the mortised stile to ...
76 Making doors and doorframes to produce the sawn, sectional sizes (which usually have at least 6mm added to the finished sizes ...
Panelled doors 77 is wound down to the machine’s depth- gauge meas- urement to remove the first few millimetres of the surplus w ...
78 Making doors and doorframes bench, against the bench- stop, and plane carefully (vigilantly) down to the gauge lines. Using t ...
Panelled doors 79 Figure 5.4 (a) Segmental- headed, 2- panelled door with raised- and- fielded panels; (b) semi- circular headed ...
80 Making doors and doorframes sandwiched, square- edged gluelam components (one vertical and two side arms). The outer, edge- m ...
Panelled doors 81 partly because the jointing of frames seems to have changed from mortises- and- tenons (requiring horns) to co ...
82 Making doors and doorframes (b) and (c) below; 2) raised and fielded panels, as at Figures 5.1(b) and (d) – section B- B – ab ...
Glazing bars 83 GLAZING BARS Figures 5.9(c)(d)(e): For single- glazed internal doors, the bars are usually moulded with the trad ...
84 Making doors and doorframes FL&B AND L&B DOORS As mentioned under Basic Door Knowledge, near the beginning of this ch ...
FL&B and L&B doors 85 the ledge- thickness) must be diagonally positioned like gallows’ brackets to support the unhinged ...
86 Making doors and doorframes cramped together face- down with at least three sash cramps, then a top ledge of ex 100 × 30mm an ...
Flush doors 87 FLUSH DOORS Nowadays, because of sophisticated and cost- effective manufacturing techniques, flush doors are not ...
88 Making doors and doorframes MAKING AN UPGRADED EXTERIOR DOOR Figures 5.13(a)(b)(c)(d)(e): Although there is a wide range of m ...
Making an upgraded exterior door 89 Figure 5.13 (b) Section A- A through the 95 × 45mm par finished top rail showing the outline ...
90 Making doors and doorframes Construction details Figure 5.13(e): Note that although the made- up panel obviously must be fitt ...
INTRODUCTION Means of climbing up or down from one floor level to another in the form of steps or stairs, have been in existence ...
«
1
2
3
4
5
6
7
8
9
»
Free download pdf