SolidWorks 2010 Bible
Chapter 7: Selecting Features FIGURE 7.36 The Keep edge option and the Keep surface option Keep features ....................... ...
Part II: Building Intelligence into Your Parts FIGURE 7.37 The Keep Feature option, both selected and unselected Part before fil ...
Chapter 7: Selecting Features Applying the values .............................................................................. ...
Part II: Building Intelligence into Your Parts If you have selected several edges, and several unassigned values are on the scre ...
Chapter 7: Selecting Features Straight versus smooth transitions ............................................................... ...
Part II: Building Intelligence into Your Parts Users almost universally ignore these messages. In the situation shown in Figure ...
Chapter 7: Selecting Features Face Fillets are sometimes amazing at covering over a mess of geometry that you might think you co ...
Part II: Building Intelligence into Your Parts To make the transition from r = ∞ to r = 2 smoothly, you would need to use a vari ...
Chapter 7: Selecting Features FIGURE 7.45 Using a Help Point with a Face Fillet Face fillet defaults to the right side Selecting ...
Part II: Building Intelligence into Your Parts faces is selected first. If this were a more commonly used feature, the interface ...
Chapter 7: Selecting Features When you edit it after it has been created, the Fillet Type panel does not appear. As a result, yo ...
Part II: Building Intelligence into Your Parts sides of the fillet are controlled, it is not possible to span between the hold l ...
Chapter 7: Selecting Features FIGURE 7.49 Examples of the double hold line fillet FIGURE 7.50 The constant width fillet No fille ...
Part II: Building Intelligence into Your Parts Applying a full round fillet The full round fillet is very useful in many situati ...
Chapter 7: Selecting Features Building a setback fillet The setback fillet is the most complex of the fillet options. You can us ...
Part II: Building Intelligence into Your Parts FIGURE 7.53 The setback fillet setup for Steps 1 through 3 Select the setback ve ...
Chapter 7: Selecting Features FIGURE 7.54 Entering setback values setback = 3 setback = 1.5 setback = 4.5 ...
Part II: Building Intelligence into Your Parts Selecting a Specialty Feature SolidWorks contains several specialty features that ...
Chapter 7: Selecting Features FIGURE 7.55 Shape features may fail in SolidWorks 2010 The Dome feature has two notable settings: ...
Part II: Building Intelligence into Your Parts Using the Wrap feature The Wrap feature enables you to wrap 2D sketches around cy ...
«
12
13
14
15
16
17
18
19
20
21
»
Free download pdf