Handbook for Sound Engineers

412 Chapter 14 the video, much as the clock is embedded with the audio bit stream in AES digital audio, so the distance limita- ...

Transmission Techniques: Wire and Cable 413 Category 1. Meets the minimum requirements for ana- log voice or plain old telephone ...

414 Chapter 14 media distance-bandwidth product of Cat 5e and Cat 6a with 802.11 (a, b, g, n) wireless media, often called Wi-Fi ...

Transmission Techniques: Wire and Cable 415 PS-NEXT. PS-NEXT, or power-sum near-end crosstalk, is the crosstalk between all of t ...

416 Chapter 14 The desired impedance for all digital audio on coaxial cable is 75:. With 1000Base-T systems, the pairs simulta ...

Transmission Techniques: Wire and Cable 417 are the bandwidth specified on the cable and the perfor- mance of the cable (attenua ...

418 Chapter 14 14.10 Coaxial Cable Coaxial cable is a design in which one conductor is accurately centered inside another with b ...

Transmission Techniques: Wire and Cable 419 tric of various cables. It will be immediately apparent that some cables have a dens ...

420 Chapter 14 14.10.3.2 Outdoor Installation Outdoor installations require special installation tech- niques that will enable t ...

Transmission Techniques: Wire and Cable 421 In fact, Table 14-22 above is not entirely accurate. The distances should be multipl ...

422 Chapter 14 time on the component parts. For instance, all Belden bundled coax cables are guaranteed to be 5 ns (nano- second ...

Transmission Techniques: Wire and Cable 423 clock frequency and is acceptable because serial digital receivers have signal recov ...

424 Chapter 14 BNC 50: connectors are often used to terminate digital video lines. This is probably acceptable if only one or tw ...

Transmission Techniques: Wire and Cable 425 Vp of 78%, and nitrogen gas injected foam has a Vp up to 86%, with current manufactu ...

426 Chapter 14 14.14.3 French BraidTM The French Braid shield by Belden is an ultraflexible double spiral shield consisting of t ...

Transmission Techniques: Wire and Cable 427 across the frequency spectrum. The combination foil-braid shield combines the advant ...

428 Chapter 14 The foil itself is much too thin and weak to even be applied in the factory by itself. The second plastic layer a ...

Transmission Techniques: Wire and Cable 429 frequencies, this means that even a correctly terminated telescopic shield is less e ...

430 Chapter 14 UTP for analog and digital connections. Where the source is not a balanced line, a device must change from balanc ...

Transmission Techniques: Wire and Cable 431 14.20 Conduit Fill To find the conduit size required for any cable, or group of cabl ...