TOYOTA PREVIA 91-97 REPAIR MANUAL

FRONT SUSPENSION COMPONENTS 1. Stabilizer bar 2. Ball joint 3. Lower control arm 4. Tie rou eno 5. Strut and coil 6. Halfshaft ...

SUSPENSION AND STEERING 8-5 Coil Springs REMOVAL & INSTALLATION I See Figures 6, 7, 8, 9 and 10 Raise and safely support th ...

8-6 SUSPENSION AND STEERING Fig. 9 Place these components in the exact order as shown for installation Out side Fig. 10 Make sur ...

SUSPENSION AND STEERING 8-7 Fig. 13 Remove the pipe attaching to the brake hoses on the strut Loosen the two nuts on the lower ...

8-8 SUSPENSION AND STEERING Tighten the two nuts on the lower portion of the shock abdbrber to 231 ft. Ibs. (314 Nm). Tighten t ...

SUSPENSION AND STEERING 8-9 Fig. 22 The ball joint will pop out of the lower control arm Remove the cotter pin. Loosen but do n ...

8-10 SUSPENSION AND STEERING Fig. 24 Remove the front left and right side engine cove s Fig. 25 Remove the retaining nut on the ...

SUSPENSION AND STEERING 8-11 Lower Arm Bracket : Specified torque ^ Cotter Pin 4 Non-reusable part Fig. 28 View of the common fr ...

8-12 SUSPENSION AND STEERING Fig. 31 Remove the arm shaft with two wrenches, use onq to hold and another to remove the nut Fig. ...

SUSPENSION AND STEERING 8-13 a. Remove the 2 nuts and bolts on the lower side of the shock absorber. b. Remove the steering knuc ...

8-14 SUSPENSION AND STERING Fig. 36 Using a flatbladed tool, pry off the grease cap models Fig. 37 With chisel and hammer, relea ...

SUSPENSION AND STEERING 8-15 4WD Fig. 42... extract the inner oil seal with a puller Fig.^44 Then press the old bearing out of t ...

8-16 SUSPENSION AND STEERING LL. JOINT CASTER IS POSITIVE WHEN THE LOAD (LOWER BALL JOINT) IS AHEAD OR PL THE SPINDLE. LLING Fig ...

REAR SUSPENSION COMPONENTS 1. Coil spring 2. Shock absorber 3. Load Sensing ProportioningValve (LSPV) spring 4. Upper control ar ...

8-18 SUSPENSION AND STEERING Coil Springs REMOVAL & INSTALLATION Raise and support the rear of the vehicle. Remove the rear ...

SUSPENSION AND STEERING 8-19 Fig. 52... a washer will come out with the bolt Fig. 54 When fluid is seeping out of the shock abso ...

8-20 SUSPENSION AND STEERING Fig. 55 Lower control arm (1), upper control arm (2) and spring (3) Install the coil spring on the ...

SUSPENSION AND STEERING 8-21 On models with ABS, remove the ABS warning harness bracket. Disconnect the Load Sensing Proportion ...

8-22 SUSPENSION AND EERING Loosen the trim pad retaining screws from the back side df the steer- ing wheel. Remove the pad by l ...

SUSPENSION AND STEERING 8-23 Fig. 63 Push down on the tab to release the clip Fig. 66 Remove the nut on the end of the steering ...