TOYOTA PREVIA 91-97 REPAIR MANUAL

7-20 DRIVE TRAIN TRANSFER CASE Extension Housing Seal REMOVAL & INSTALLATION Using a hammer and chisel, loosen the staked n ...

DRIVE TRAIN 7-21 DRIVELINE The driveshafts are designed for the 2WD and 4WD use. The 2WD shafts are a 2-joint type. Manual trans ...

7-22 DRIVE TRAIN Fig. 66 Two wrenches are needed to remove the four bolts;, and sometimes an air wrench Fig. 69 ... and using tw ...

DRIVE TRAIN 7-23 U-JOINT REPLACEMENT I See Figures 72 thru 80 Place matchmarks on the shaft and yoke. Using a brass bar and ham ...

7-24 DRIVE TRAIN Fig. 77 Always apply MP grease (but not too much) when installing a new bearings to the spider gear Color Green ...

DRIVE TRAIN 7-25 Shell Type Propeller Shaft Assembly Solid Type TMC-made: Spider Bearing - Spider Bearing + Snap Ring Flange Yok ...

7-26 DRIVE TRAIN v. «to: Fig. 82 View of the common rear driveshaft on the 4WD nodels Fig. 83 Place matchmarks on the driveshaft ...

DRIVE TRAIN 7-27 Fig. 88 Make sure the matchmarks line up when installing the driveshaft On 4WD, align the matchmarks on the tr ...

7-28 DRIVE TRAIN Using a chisel and hammer, loosen the staked portion of:he nut. Use two tools to retain the flange and remove ...

DRIVE TRAIN 7-29 Remove the caliperand disc. Loosen the 2 nuts on the lower side of the shock absorber. -»Do not remove the bol ...

7-30 DRIVE TRAIN Fig. 98 Tapping in a new dust deflector Companion Range Oil Sllnger Non-reusable part Fig. 99 The front 4WD dif ...

DRIVE TRAIN 7-31 SST Fig. 102 ... then extract the oil seal using a puller bolts, 6 cushions and collars. Lower the jack and rem ...

7-32 DRIVE TRAIN REAR AXLE Axle Shaft, Bearing and Seal I See Figure 106 REMOVAL & INSTALLATION With Drum Brakes I See Figur ...

DRIVE TRAIN 7-33 Fig. 107 Use a slide hammer puller to extract the axle shaft from the housing w/ABS SST Fig. 108 Press out the ...

7-34 DRIVE TRAIN Fig. 110 These four nuts retain the backing plate on the axle rear *# WARNING When removing the bearing, be car ...

DRIVE TRAIN 7-35 SST Fig. 113 Use a screw type puller and remove the companion flange... Fig. 116 Use a torque meter to measure ...

7-36 DRIVE TRAIN /^ Brake Drum Axle Shaft and Brake Assembly «•""' 4 Non-reusable part Fig. 117 Exploded view of the rear axle a ...

8-2 8-2 8-10 WHEELS 8-2 WHEEL ASSEMBLY 8-2 REMOVAL & INSTALLATION INSPECTION 8-2 WHEEL LUG STUDS 8-2 REMOVAL & INSTALLAT ...

8-2 SUSPENSION AND STBERING WHEELS Wheel Assembly REMOVAL & INSTALLATION from their »See Figure 1 Park the vehicle on a lev ...

SUSPENSION AND STEERING 8-3 STUD ROTOR Fig. 2 View of the rotor and stud assembly C-FRAME AND CLAMP ASSEMBLY Fig. 4 Use a C-clam ...