TOYOTA PREVIA 91-97 REPAIR MANUAL

1-18 GENERAL INFORMATIONAND MAINTENANCE ...

GENERAL INFORMATION AND MAINTENANCE 1-19 Proper maintenance and tune-up is the key to long and trouble-free vehicle life, and th ...

1-20 GENERAL INFORMATION AND MAINTENANCE Fig. 38 The fuel filter is mounted on the drivers side under the vehicle with two bolts ...

GENERAL INFORMATION AND MAINTENANCE 1-21 Fig. 44 If necessary, remove the bracket from the old filter Fig. 45 Remove these two b ...

1-22 GENERAL INFORMATION AND MAINTENANCE Fig. 48 Remove the two bolts retaining the jack bracket Fig. 49 Lift out the jack brack ...

GENERAL INFORMATION AND MAINTENANCE 1-23 ' ••'.•:'•••== v : •' •' ••• II I / •'••- Fig. 54 The PCV valve is recessed in the grom ...

1-24 GENERAL INFORMATIONAND MAINTENANCE Always visually inspect the battery case for cracks, leakage and cojiro- sion. A white c ...

GENERAL INFORMATION AND MAINTENANCE 1-25 Fig. 59 If the fluid level is low, add only distilled water through the opening until t ...

1-26 GENERAL INFORMATIONAND MAINTENANCE Fig. 64 A special tool is available to pull the clamp from the post Fig. 65 The cable en ...

GENERAL INFORMATION AND MAINTENANCE 1-27 Fig. 67 An example of a healthy drive belt Fig. 70 Installing too wide a belt can resul ...

1-28 GENERAL INFORMATION AND MAINTENANCE ALALTERNATOR CC:COOLER COMPRESSOR CKiCRANKSHAFT DP:DRIVE PULLEY I P:!DLE PULLEY SC:SUPE ...

GENERAL INFORMATION AND MAINTENANCE 1-29 Fig. 76 The cracks developing along this hose are a result of age-related hardening Fig ...

1-30 GENERAL INFORMATION AND MAINTENANCE •»lf the hose is stuck at the connection, do not try to insert a screw- driver or other ...

GENERAL INFORMATION AND MAINTENANCE 1-31 across which the current can arc. The coil produces anywhere from 20,000 to 50,000 volt ...

1-32 GENERAL INFORMATION AND MAINTENANCE! Fig. 86 Carefully twist and remove the spark plug wires Fig. 88 Check the condition of ...

GENERAL INFORMATION AND MAINTENANCE 1-33 a. Tighten the bolts to the following specifications: Service hole cover bolts—10 ft. I ...

1-34 GENERAL INFORMATION AND MAINTENANCE never be gapped or cleaned. Inspect the plugs for damage and depos can give you a good ...

GENERAL INFORMATION AND MAINTENANCE 1-35 • Fig. 94 Be sure to place the wires in the correct locations Fig. 96 Check the inside ...

1-36 GENERAL INFORMATION AND MAINTENANCE As you accelerate from idle, the speed of your engine (rpm) increases. The increase in ...

GENERAL INFORMATION AND MAINTENANCE 1-37 TE1 SST Fig. 100 Using the SST 09843-18020 or a jumper wire, connect terminals TE1 and ...