TOYOTA PREVIA 91-97 REPAIR MANUAL

1-78 GENERAL INFORMATION AND MAINTENANCE ENGLISH TO METRIC: CONVERSION: MASS (WEIGHT) Current mass measurement is expressed in p ...

GENERAL INFORMATION AND MAINTENANCE 1-79 ENGLISH TO METRIC CONVERSION:LENGTH To convert inches (ins.) to millimeters (mm): multi ...

1-80 GENERAL INFORMATION AND MAINTENANCE ENGLISH TO ME RIC CONVERSION: TORQUE Torque is now expressed as either foot-pounds (ft. ...

GENERAL INFORMATION AND MAINTENANCE 1-81 ENGLISH TO METRIC CONVERSION: FORCE Force is presently measured in pounds (Ibs.). This ...

1-82 GENERAL INFORMATION AND MAINTENANCE ENGLISH TO METRIC CONVERSION: LIQUID CAPACITY Liquid or fluid capacity is presently exp ...

GENERAL INFORMATION AND MAINTENANCE 1-83 ENGLISH TO METRIC CONVERSION: PRESSURE The basic unit of pressure measurement used toda ...

1-84 GENERAL INFORMATION AND MAINTENANCE ENGLISH TO METRIC CONVERSION: PRESSURE _^__^____:_-—,-:,_J_^ ,. -- , The basic unit of ...

ELECTRONIC SPARK ADVANCE SYSTEM 2-2 GENERAL INFORMATION 2-2 DIAGNOSIS AND TESTING 2-2 NO START TEST 2-2 SIGNAL GENERATOR AIR GAP ...

2-2 ENGINE ELECTRICAL ELECTRONIC SPARK ADVANCE SYSTEM *f or information on understanding electricity and troubleshooting electri ...

ENGINE ELECTRICAL 2-3 SPARK TEST 1 CHECK CONNECTION OF IGNITION COIL, IGNITER AND DISTRIBUTOR CONNECTOR [fifl t OK CORD » OK CHE ...

2-4 ENGINE ELECTRICAL 0.2 - 0.5mm Fig. 8 Measure the air gap in this position with a non-ferro is feeler gauge—2TZ-FZE engines F ...

ENGINE ELECTRICAL 2-5 Fig. 11 Release the clip on the tip of the coil wire Fig. 14 Extract the coil with bracket from the floor ...

2-6 ENGINE ELECTRICAL Distributor Housing Assembw if O-Ring Distributor Cap Fig. 15 Exploded view of the distributor assembly W9 ...

ENGINE ELECTRICAL 2-7 Fig. 21 Place matchmarks on the housing and rotor positions Fig. 24... and pull out the distributor assemb ...

2-8 ENGINE ELECTRICAL Engine Rotated I See Figures 25, 26 and 27 If the engine was disturbed while the distributor was removed ...

ENGINE ELECTRICAL 2-9 CHARGING SYSTEM General Information The charging system is a negative (-) ground system which consists of ...

2-10 ENGINE ELECTRICAL f. If the voltmeter reading is more than standard voltage, repiace the voltage regulator. If the voltmete ...

ENGINE ELECTRICAL 2-11 Fig. 35 Pull the lock bolt from the lower portion of the alternator Fig. 36 Extract the alternator from t ...

2-12 ENGINE ELECTRICAL To install: Position the alternator with the 3 bolts and tighten the alternator I 37 ft. Ibs. (50 Nm). Ti ...

ENGINE ELECTRICAL 2-13 Terminal 50 Terminal C Fig. 40 Pull-in test terminal connections Fig.^42 Clutch pinion gear return termin ...