TOYOTA PREVIA 91-97 REPAIR MANUAL

1-16 ENGINE AND ENGINE OVERHAUL Fig. 34 It is always a good idea to plug the line once removed Fig. 35 Remove the upper shroud r ...

ENGINE AND ENGINE OVERHAUL 3-17 Connect the radiator hoses. 17. On 1995-97 vehicles, connect the water bypass hose from the thr ...

3-18 ENGINE AND ENGINE 0 ^ERHAUL Fig. 44 Remember to discard the old gasket for the bracket Fig. 45 Remove any hoses attached to ...

ENGINE AND ENGINE OVERHAUL 3-19 Fig. 50 View of the water pump gasket mating area Equipment Driveshaft PRECAUTIONS I See Figures ...

3-20 ENGINE AND ENGINE OVERHAUL CORRECT WRONG Fig. 54 Only store the shaft in a straight line without bend ng it Fig.^57 Check a ...

ENGINE AND ENGINE OVERHAUL 3-21 Equipment Drive Shaft I forDrive Supercharge Bei! Drivefor PS and Belt Generator Fig. 59 View of ...

3-22 ENGINE AND ENGINE OVERHAUL Fig. 62 Unbolt and extract the No. 1 intake air connector bracket Fig. 63 Three bolts retain the ...

ENGINE AND ENGINE OVERHAUL 3-23 Fig. 67 Unbolt the equipment driveshaft and drive housing Fig.^70 Rotate the flange and check th ...

3-24 ENGINE AND ENGINE OVERHAUL Matchmarks Fig. 72 Align the matchmarks and install the 3 washers wi h bolts to the shaft coupli ...

ENGINE AND ENGINE OVERHAUL 3-25 Front CORRECT WRONG WRONG 90913G55 Fig. 77 Align the insulators at the front correctly Install ...

3-26 ENGINE AND ENGINE OVERHAUL Hole Hole Knock Pin Knock RSn Fig. 81 Aligning the hole with the knock pin when installir insula ...

ENGINE AND ENGINE OVERHAUL 3-27 Uniformly remove the head bolts following the sequence. ••The cylinder head is positioned on t ...

3-28 ENGINE AND ENGINE O'i/ERHAUL Painted Mark Front Fig. 90 Mark the front of the head bolt with paint Painted Mark Fig. 91 Ret ...

ENGINE AND ENGINE OVERHAUL 3-29 No. 2 Cylinder Head Cover flH Fran! Engi Mounting + Non-reusable part Fig. 93 Exploded view of ...

3-30 ENGINE AND ENGINE OVERHAUL Fig. 95 Unbolt and remove the engine wire Relieve the fuel system pressure. * CAUTION Fuel inj ...

ENGINE AND ENGINE OVERHAUL 3-31 Remove the intake manifold. Remove the right side engine mounting. Remove the exhaust manifold ...

3-32 ENGINE AND ENGINE (JVERHAUL Oil Level Sensor- * Engine Cooian Drain Cock Non-reusable part Precoated part Fig. 103 No. 1 oi ...

ENGINE AND ENGINE OVERHAUL 3-33 Do Not Remove Fig. 106 Remove only these twelve bolts not the other three shown Fig. 107 Tight ...

3-34 ENGINE AND ENGINE OVERHAUL Install the oil pressure switch, left engine mount and stay, lighten the left engine mount bolt ...

ENGINE AND ENGINE OVERHAUL 3-35 No.2 Engine Hange 1 Camshaft Timing Gea Dampi LH Front Engine Mounting Crankshaft Pulley Mountin ...