TOYOTA PREVIA 91-97 REPAIR MANUAL

ENGINE ELECTRICAL 2-3 SPARK TEST 1 CHECK CONNECTION OF IGNITION COIL, IGNITER AND DISTRIBUTOR CONNECTOR [fifl t OK CORD » OK CHE ...

2-4 ENGINE ELECTRICAL 0.2 - 0.5mm Fig. 8 Measure the air gap in this position with a non-ferro is feeler gauge—2TZ-FZE engines F ...

ENGINE ELECTRICAL 2-5 Fig. 11 Release the clip on the tip of the coil wire Fig. 14 Extract the coil with bracket from the floor ...

2-6 ENGINE ELECTRICAL Distributor Housing Assembw if O-Ring Distributor Cap Fig. 15 Exploded view of the distributor assembly W9 ...

ENGINE ELECTRICAL 2-7 Fig. 21 Place matchmarks on the housing and rotor positions Fig. 24... and pull out the distributor assemb ...

2-8 ENGINE ELECTRICAL Engine Rotated I See Figures 25, 26 and 27 If the engine was disturbed while the distributor was removed ...

ENGINE ELECTRICAL 2-9 CHARGING SYSTEM General Information The charging system is a negative (-) ground system which consists of ...

2-10 ENGINE ELECTRICAL f. If the voltmeter reading is more than standard voltage, repiace the voltage regulator. If the voltmete ...

ENGINE ELECTRICAL 2-11 Fig. 35 Pull the lock bolt from the lower portion of the alternator Fig. 36 Extract the alternator from t ...

2-12 ENGINE ELECTRICAL To install: Position the alternator with the 3 bolts and tighten the alternator I 37 ft. Ibs. (50 Nm). Ti ...

ENGINE ELECTRICAL 2-13 Terminal 50 Terminal C Fig. 40 Pull-in test terminal connections Fig.^42 Clutch pinion gear return termin ...

2-14 ENGINE ELECTRICAL Fig. 44 Disengage the starter wiring Fig. 45 Remove the cap hiding the nut Fig. 46 It will be necessary t ...

ENGINE ELECTRICAL 2-15 2WD Fig. 50 Bolt locations on the 2WD models 4WO Fig. 51 Bolt locations on the 4WD models Remove the nut ...

2-16 ENGINE ELECTRICAL SENDING UNITS AND SENSORS General Information »See Figure 53 —This section describes the operating princi ...

ENGINE ELECTRICAL 2-17 Disconnect the sending unit electrical harness. Using an ohmmeter, check continuity of the sending unit ...

2-18 ENGINE ELECTRICAL Troubleshooting Ba Problem Sic Charging System Problems Cause Solution Noisy alternator Loose mountings L ...

ENGINE MECHANICAL 3-2 ENGINE 3-6 REMOVAL & INSTALLATION 3-6 ROCKER ARM (VALVE) COVER 3-7 REMOVAL & INSTALLATION 3-7 THER ...

3-2 ENGINE AND ENGINE OVERHAUL ENGINE MECHANICAL ENGINE! MECHANICAL SPECIFICATIONS Description English Specifications Metric Spe ...

ENGINE AND ENGINE OVERHAUL 3-3 ENGINE MECHANICAL SPECIFICATIONS Description English Specifications Metric Specifications Camshaf ...

3-4 ENGINE AND ENGINE OVERHAUL ENGIN Description Piston and Rings continued: Piston ring end gap STD No. 1 No. 2 oil limit No. 1 ...