TOYOTA PREVIA 91-97 REPAIR MANUAL

BRAKE OPERATING SYSTEM 9-2 BASIC OPERATING PRINCIPLES 9-2 DISC BRAKES 9-2 DRUM BRAKES 9-2 POWER BOOSTERS 9-3 BRAKE LIGHT SWITCH ...

9-2 BRAKES BRAKE OPERATING SYSTEM Basic Operating Principles Hydraulic systems are used to actuate the brakes of all moderil] au ...

BRAKES 9-3 these links bear directly against the top of the brake shoes, the tops of the shoes are then forced against the inner ...

9-4 BRAKES Fig. 3 Disconnect the level warning harness from the brake master cylinder Fig. 4 Siphon out the old brake fluid from ...

BRAKES 9-5 Fig. 9 Extract the master cylinder from the four studs from the brake booster Fig. 10 Remove and discard the old gask ...

9-6 BRAKES Fig. 12 Remove the clip to slide the clevis pin out of the clevis pedal SST Gasket Fig. 13 Install the tool on top of ...

BRAKES 9-7 Fill the brake master cylinder with fresh brake fluid, then bleed the brake system. Check and adjust the fluid press ...

9-8 BRAKES Front brake pressure kPa (kgf/cm', psi} 8,826 (90, 1,280) Rear brake pressure kPa (kgf/cm', psi) 6,659 - 7,639 (67.9 ...

BRAKES 9-9 Fig. 25 Use a brush to clean the fittings of any debris Fig. 28 Inspect the hose threads and pipe ends when they are ...

9-10 BRAKES Fig. 31 Remove this bolt... ' ' l Fig. 34 Any gaskets/crush washers should be replaced with new ones during installa ...

BRAKES 9-11 Thoroughly clean the surrounding area at the joints to be disconnected. Place a suitable catch pan under the joint ...

9-12 BRAKES Check the level of the fluid in the reservoir. If necessary, fill wit i fluid. Disconnect the brake lines from the ...

BRAKES 9-13 DISC BRAKES ** CAUTION Brake fluid contains poiyglycol ethers and polyglycols. Avoid contact with the eyes and wash ...

9-14 BRAKES Fig. 47 A hanger is a good tool to suspend a caliper out (if the way Fig.^50 There should be two plates on each brak ...

BRAKES 9-15 Fig. 53 Lubricate the sliding pin. Install the front wheels and lower the vehicle. Check the fluid level in the mas ...

9-16 BRAKES Fig. 58 ... support it with a cord or hanger wire Fig. 61 Compress the piston to install the pads Fig. 62 Be sure th ...

BRAKES 9-17 Remove the lower installation bolt. Lift up the caiiper and suspend it securely. Do not remove the upper installati ...

9-18 BRAKES Fig. 67 The lower bolt is larger than the top Fig. 68 The entire caliper should slide off the disc Fig. 69 Two bolts ...

BRAKES 9-19 Remove the caliper from the vehicle and place on a clean work- bench. * CAUTION NEVER place your fingers in front ...

9-20 BRAKES Fig. 77 Use extreme caution when removing the piston se NOT scratch the caliper bore TCCA9P06 il;DO Fig. 78 Use the ...