TOYOTA PREVIA 91-97 REPAIR MANUAL

DRIVE TRAIN 7-9 Driven Disc and Pressure Plate REMOVAL & INSTALLATION I See Figures 24 thru 35 Remove the transmission asse ...

7-10 DRIVE TRAIN Fig. 29 Be sure that the flywheel surface is clean, before installing the clutch Fig. 30 Check across trie flyw ...

DRIVE TRAIN 7-11 Fig. 35 Grease points of the release fork Push Rod Play Adjust Point Pedal Height Adjust Point Push Rod Play 90 ...

7-12 DRIVE TRAIN 25 mm (0.98 in.) or mor« ease Full Stroke End Position Fig. 38 Gradually depress the clutch pedal and measure t ...

DRIVE TRAIN 7-13 Fig. 41 The clutch accumulator is located near the carbon canis- ter Fig. 42 Have an assistant pump the clutch ...

7-14 DRIVE TRAIN ONE-WAY CLUTCH HOUSING FLUID ENGINE CRANKSHAFT TURBINE SHAFT Fig. 44 The torque converter housing is rotated by ...

DRIVE TRAIN 7-15 SUN GEAR HELD RING GEAR DRIVES PLANET CARRIER DRIVEN TCCS7014 Fig. 47 Planetary gears in the minimum reduction ...

7-16 DRIVE TRAIN Fig. 5D Disconnect the lines on the oil cooler Fig. 53 Remove the nut on the neutral safety switch Fig. 51 Remo ...

DRIVE TRAIN 7-17 Fig. 56 Extract the switch from the transmission Unstake the lockwasher. Remove the nut and bolt, then extract ...

7-18 DRIVE TRAIN _0il Cooler Pipe (2WD) Oil Cooler Pipe (4WD) Filler Tube -Rear Mounting Torque Converter Converter Cov Starter ...

DRIVE TRAIN 7-19 Support the transmission, using a jack with a wooden block placed between the jack and the transmission pan. R ...

7-20 DRIVE TRAIN TRANSFER CASE Extension Housing Seal REMOVAL & INSTALLATION Using a hammer and chisel, loosen the staked n ...

DRIVE TRAIN 7-21 DRIVELINE The driveshafts are designed for the 2WD and 4WD use. The 2WD shafts are a 2-joint type. Manual trans ...

7-22 DRIVE TRAIN Fig. 66 Two wrenches are needed to remove the four bolts;, and sometimes an air wrench Fig. 69 ... and using tw ...

DRIVE TRAIN 7-23 U-JOINT REPLACEMENT I See Figures 72 thru 80 Place matchmarks on the shaft and yoke. Using a brass bar and ham ...

7-24 DRIVE TRAIN Fig. 77 Always apply MP grease (but not too much) when installing a new bearings to the spider gear Color Green ...

DRIVE TRAIN 7-25 Shell Type Propeller Shaft Assembly Solid Type TMC-made: Spider Bearing - Spider Bearing + Snap Ring Flange Yok ...

7-26 DRIVE TRAIN v. «to: Fig. 82 View of the common rear driveshaft on the 4WD nodels Fig. 83 Place matchmarks on the driveshaft ...

DRIVE TRAIN 7-27 Fig. 88 Make sure the matchmarks line up when installing the driveshaft On 4WD, align the matchmarks on the tr ...

7-28 DRIVE TRAIN Using a chisel and hammer, loosen the staked portion of:he nut. Use two tools to retain the flange and remove ...