目录.p65
Supplemental restraint system--Inspection Automobile is not impacted: a. Make malfunction diagnostic inspection, b. Check the s ...
Supplemental restraint system--Remove malfunction Remove malfunction........................................... Malfunction tabl ...
Supplemental restraint system--Remove malfunction Diagnostic procedure When starting to check, firstly, use special diagnostic t ...
(3) Confirm the malfunction will not happen again after repairing, a. Set ignition switch at LOCK position, b. Cut off cathode o ...
Diagnostic procedure (1) Check the battery z Is the voltage higher than 9V? Yes: make next operation, No: The voltage of battery ...
Malfunction at the side of driver Malfunction of safety airbag at the side of driver (resistance is too big or too small, shor ...
(4) Check the wiring harness between helix cable and electronic control unit of safety airbag system a. Set ignition switch at L ...
a. Set ignition switch at LOCK position, b. Loosen the cathode cable of battery and keep this state for one minute at least, c. ...
Malfunction of pre-tension safety belt (resistance is too big or too small, short circuit, grounding and so on) Test condition W ...
d. Loosen the connectors of all safety airbag system units, e. Check whether the connector between electronic control unit of sa ...
Diagnosis of impacted automobile................. No matter whether the safety airbag has been unfolded, the inspection and main ...
Supplemental restraint system--Disassemble and assemble Disassemble and assemble............................... Electronic contr ...
Supplemental restraint system--Disassemble and assemble (4) Disassemble the joint of loudspeaker and airbag wiring harness. (5) ...
Safety airbag assemble at the side of passenger.... Note (referring to chapter 1). Use the flash or malfunction diagnostic tool ...
Scrap treatment for safety airbag.................. Hint: z When scraping a automobile with SRS or disposing safety airbag modul ...
Only scrap airbag module Explosion of safety airbag assembly at the side of driver. (1) Prepare a battery as detonating power ( ...
Supplemental restraint system--Scrap treatment for safety airbag (3) Fix the module on wheel. a. Assemble two bolts with gasket ...
(3) Fix the module on wheel. a. Assemble three bolts with gasket on two assembling holes of left, middle and right support pin o ...
Supplemental restraint system--Scrap treatment for safety airbag b. Use maintenance electric wire used for automobile to fix saf ...
Supplemental restraint system--Scrap treatment for safety airbag Special tool Safety airbag assembly at the side of passenger Ba ...
«
9
10
11
12
13
14
15
16
17
18
»
Free download pdf