目录.p65
Water temperature sensor (4G18-3600040) This sensor applies sealing NTC thermal resistor in temperature sensor, and resistance ...
Characteristic curve of intake air temperature sensor NTC resistor Characteristic curve of temperature sensor Stepping motor ofi ...
Pins: Pin A is connected to ECU No. 65 pin Pin B is connected to ECU No. 66 pin Pin C is connected to ECU No. 67 pin Pin D is co ...
Engine control system·- Throttle body assembly Throttle body assembly........................................ Removing, installi ...
Fuel Fuel system Precautions...................................................... Before repairing fuel system, uncouple batte ...
Fuel-Fuel system (1) It is not allowed to use o-ring repeatedly. (2) When installing o-ring, always be careful to avoid dam- agi ...
On-vehicle inspection...................................... Inspection of fuel pump function (a) Connect hand-held tester to di ...
(6) Connect special tool to injection nozzle joint. (7) Connect special tool to battery for 15 seconds, and measure the injectio ...
Fuel-Injection nozzle assembly Injection nozzle assembly.................................... Replacement........................ ...
Fuel-Injection nozzle assembly Install fuel rail component [4G18-1112110]. (a) Check injection nozzle o-ring and replace if the ...
Fuel - Fuel pump assembly Fuel pump assembly........................................... Removing, installing and disassembling, ...
Fuel - Fuel tank assembly Fuel tank assembly............................................. Take measures to prevent gasoline lea ...
Fuel - Fuel tank assembly Be careful of the contaminant that looked like dirt, because fast-joint depends on o-ring to seal fuel ...
Exhaust gas control Exhaust gas control system On-vehicle inspection...................................... Check oxygen sensor. ...
Check heater resistance of heated oxygen sensor. (a) Uncouple oxygen sensor joint. (b) Place digital universal meter at ohm gea ...
Exhaust gas control - Exhaust gas control system PCV valve assembly [4G18-1014110] (a) Blow air into valve from cylinder side a ...
Engine mechanism Engine assembly Inspection........................................................ Check coolant. Check engine ...
Check compression pressure. (a) Warm up engine. (b) Remove ignition coil. (c) Remove spark plug. (d) Check cylinder compression ...
Engine mechanism - Engine assembly CO HC Trouble occurrence Possible causes 28 Normal High Unstable idle speed Low High Unstable ...
Engine mechanism - Drive belt Drive belt.............................................................. Replacement.............. ...
«
1
2
3
4
5
6
7
8
9
10
»
Free download pdf