Simulink Control Design™ - MathWorks

Enable regular expression Enable the use of MATLAB regular expressions for filtering signal names. For example, entering t$ in t ...

Settings Default: Off On Display the filtered list of signals using a flat list format, indicating bus hierarchies with dot nota ...

Settings Default: Simulation snapshots Simulation snapshots Specific simulation time, specified in Snapshot times on page 16-116 ...

Snapshot times One or more simulation times. The linear system is computed at these times. Settings Default: 0 For a different ...

Rising edge Rising edge of the external trigger signal. Falling edge Falling edge of the external trigger signal. Dependencies S ...

As shown in the following figure, when zero-crossing detection is enabled, the variable-step Simulink solver simulates the model ...

“Verify Model at Default Simulation Snapshot Time” on page 14-6 Use exact delays How to represent time delays in your linear mod ...

Resample a discrete-time system with a different sample time Compute a continuous-time system from a discrete-time system When ...

Sample time rate conversion method Method for converting the sample time of single-rate or multirate models. This parameter is u ...

You can upsample only when you convert a discrete-time system to a new faster sample time that is an integer multiple of the sam ...

Dependencies Selecting either Tustin with Prewarping Upsampling when possible, Tustin with Prewarping otherwise in Sample time ...

On Show state and input/output names with their path through the model hierarchy. For example, in the chemical reactor model, a ...

Bus signal names appear when the input and output are at the output of the following blocks: Root-level inport block containing ...

You can view the gain and phase margin bound on one of the following plot types on page 16-137: Bode Nichols Nyquist Table If ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

“Verify Model at Default Simulation Snapshot Time” on page 14-6 Phase margin (deg) > Phase margin, specified in degrees. By d ...

Feedback sign Feedback sign to determine the gain and phase margins of the linear system, computed during simulation. To determi ...

Save data to workspace Save one or more linear systems to perform further linear analysis or control design. The saved data is i ...

Dependencies This parameter enables Variable name on page 16-131. Command-Line Information Parameter: SaveToWorkspace Type: char ...

Dependencies Save data to workspace on page 16-130 enables this parameter. Command-Line Information Parameter: SaveName Type: ch ...