Simulink Control Design™ - MathWorks

Value: 'on' | 'off' Default: 'off' See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verif ...

Settings Default: On On Check that bounds included for assertion in the Bounds tab are satisfied during simulation. A warning, r ...

A MATLAB expression. Dependencies Enable assertion on page 16-133 enables this parameter. Command-Line Information Parameter: ca ...

Tips Because selecting this option stops the simulation as soon as the assertion fails, assertion failures that might occur lat ...

Off Do not output a Boolean signal to indicate assertion status. Tips Use this parameter to design complex assertion logic. For ...

Right-click the Bode, Nichols, or Nyquist plot, and select Characteristics > Minimum Stability Margins to view gain and phase ...

Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot Linear Characteristics of Simulink Models During Simulat ...

• Simulating the model by clicking or selecting Simulation > Start. This action also linearizes the portion of the model betw ...

“Plotting Linear System Characteristics of a Chemical Reactor” on page 2-126 Introduced in R2010b Gain and Phase Margin Plot ...

Linear Step Response Plot Step response of linear system approximated from nonlinear Simulink model Library Simulink Control Des ...

Evaluate a MATLAB expression. Stop the simulation and bring that block into focus. During simulation, the block can also outpu ...

Task Parameters Specify algorithm options. In Algorithm Options of Linearizations tab: “Enable zero-crossing detection” on page ...

Task Parameters Specify assertion options (only when you specify bounds on the linear system). In Assertion tab: “Enable assert ...

The selected signals appear under Model signal in the Click a signal in the model to select it area. (^3) (Optional) For buses, ...

TipTo find the location in the Simulink model corresponding to a signal in the Linearization inputs/outputs table, select the si ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

lowercase t (and their immediate parents). For details, see “Regular Expressions” (MATLAB). Settings Default: On On Allow use of ...

Settings Default: Off On Display the filtered list of signals using a flat list format, indicating bus hierarchies with dot nota ...

Settings Default: Simulation snapshots Simulation snapshots Specific simulation time, specified in Snapshot times on page 16-152 ...

Snapshot times One or more simulation times. The linear system is computed at these times. Settings Default: 0 For a different ...