SolidWorks 2010 Bible
Chapter 3: Working with Sketches l (^) Tangent to Two Entities. Start the circle with the cursor near one line in the sketch. A ...
Part I: SolidWorks Basics FIGURE 3.7 Using the Tangent Arc feature Perpendicular Original line Reverse tangent Tangent 3 Point A ...
Chapter 3: Working with Sketches FIGURE 3.9 Creating a sketch fillet Select lines Select Result Centerline follows the same meth ...
Part I: SolidWorks Basics FIGURE 3.10 The structure of a spline and spline handles Control polygon Inflection point Combination ...
Chapter 3: Working with Sketches work to this course, you should look into some of the shortcomings of 3D Planes. The planes are ...
Part I: SolidWorks Basics FIGURE 3.11 The Offset Entities interface The options available in the Offset Entities interface are a ...
Chapter 3: Working with Sketches FIGURE 3.12 The results of using offset entities cap ends FIGURE 3.13 The Trim interface l (^) ...
Part I: SolidWorks Basics You can also use power trim to extend sketch entities along their paths by dragging the endpoints. Reg ...
Chapter 3: Working with Sketches l (^) Trim away outside. Functions exactly like the Trim away inside option, except that sketch ...
Part I: SolidWorks Basics Construction Geometry toggles between regular sketch entities and construction entities. Construction ...
Chapter 3: Working with Sketches Tip The main ideas to remember with the Stretch tool are that it is used to stretch dimensioned ...
Part I: SolidWorks Basics FIGURE 3.19 The Move Entities interface Polygon creates a regular n-sided polygon in the same way as a ...
Chapter 3: Working with Sketches FIGURE 3.20 Drawing a parabola Apex Focus Click+drag Sketch Text creates editable text in sketc ...
Part I: SolidWorks Basics FIGURE 3.21 The Sketch Text interface Curve for text to follow Sketch text Bold, italics, rotate Justi ...
Chapter 3: Working with Sketches Split Entities splits a sketch entity into two segments. You can also delete it later to rejoin ...
Part I: SolidWorks Basics Best Practice You should use sketch patterns as little as possible. For many of the same reasons that ...
Chapter 3: Working with Sketches move (such as a collinear relation), you are prompted with a choice to delete the existing rela ...
Part I: SolidWorks Basics The result is a proportional spline in a sketch, not a curve feature as the name suggests. New in Soli ...
Chapter 3: Working with Sketches Straight Slot and Curved Slot draw slots of a given width and length with full rounds on the en ...
Part I: SolidWorks Basics l^ Vertical Dimension. Works like a horizontal dimension but vertically. l^ Baseline Dimensions. Creat ...
«
3
4
5
6
7
8
9
10
11
12
»
Free download pdf