SolidWorks 2010 Bible
Chapter 3: Working with Sketches FIGURE 3.30 Options for Ordinate Dimensions Horizontal and Vertical Ordinate Dimensions have th ...
Part I: SolidWorks Basics While sketching, symbols appear on the cursor to show that a relation will automatically be cre- ated. ...
Chapter 3: Working with Sketches TABLE 3.1 Symbols Along X Along Y Along Z At Intersection of Two Faces Coincident Collinear Con ...
Part I: SolidWorks Basics FIGURE 3.33 The Fully Define Sketch interface Exploring Sketch Settings In addition to sketch tools, a ...
Chapter 3: Working with Sketches Detach Segment on Drag is turned off by default. When you turn this setting on, the Detach Segm ...
Part I: SolidWorks Basics l^ Edit Block. Enables you to edit an existing block as if it were a regular sketch. l Insert Block. E ...
Chapter 3: Working with Sketches Working with Reference Geometry Reference geometry in SolidWorks is used to help establish loca ...
Part I: SolidWorks Basics FIGURE 3.35 Creating a new plane from a set of selections and constraints Note When you start using th ...
Chapter 3: Working with Sketches Note The interface for the Axis feature has not been changed to match the Plane interface as of ...
Part I: SolidWorks Basics FIGURE 3.37 Use Coordinate Systems to export parts and assemblies with a new origin location. FIGURE 3 ...
Chapter 3: Working with Sketches Using points as reference geometry The Point reference geometry feature is infrequently used; h ...
Part I: SolidWorks Basics Move the cursor near the Origin; the yellow Coincident symbol appears. Draw a line horizontal from th ...
Chapter 3: Working with Sketches has created virtual sharps. Figure 3.41 shows the sketch at this point. You may now want to tur ...
Part I: SolidWorks Basics Click the Trim tool from the Sketch toolbar. Make sure that the Trim option is set to Closest. Click ...
Chapter 3: Working with Sketches Open a new part with inches as the units. Draw a sketch on the Front plane as shown in Figure ...
Part I: SolidWorks Basics FIGURE 3.45 Creating a block The items in the block now turn gray. Click anywhere on the block and dr ...
Chapter 3: Working with Sketches FIGURE 3.46 Block placement Tutorial: Reference Geometry This tutorial steps you through creati ...
Part I: SolidWorks Basics Select the inside face of a hole on the part, as shown in Figure 3.47. This creates an axis on the ce ...
Chapter 3: Working with Sketches FIGURE 3.48 Creating a plane from tangent and coincident constraints Note If the view is alread ...
Part I: SolidWorks Basics Use the Smart Dimension tool to apply dimensions, as shown in Figure 3.49. Note that the 3.450-inch d ...
«
4
5
6
7
8
9
10
11
12
13
»
Free download pdf