Mechanical APDL Basic Analysis Guide

d,all,all,0.0! Fix one end nsel,all solve save finish /post1 set,last esel,s,elem,,1 /com -------------------------------------- ...

AUTOTS,1 NSUBST,1000,1000,10 KBC,0 OUTRES,ALL,10, inistate,write,1,,,,-1,s inistate,write,1,,,,-1,eppl inistate,write,1,,,,-1,pl ...

FINISH /POST26 /OUT /com ------------------------------------------------------------------------- /com | The deflections in y d ...

block,0,1,0,1,0,1 esize,0.5 vmesh,all nsel,s,loc,x,0 d,all,ux nsel,s,loc,y,0 d,all,uy nsel,s,loc,z,0 d,all,uz allsel,all cdwrite ...

/com *********************************************************************** /com Second case: analysis with INISTATE command /c ...

mp,ex,1,210e9! Pa mp,nuxy,1,.29! No units mp,dens,1,7850! kg/m3 et,1,182 rectng,0,10,0,2, esize,0.5 amesh,all nsel,s,loc,x d,all ...

file,,rstp set,list fini 4.7. Writing Initial State Values Issue an INISTATE,WRITE command (available in the solution processor ...

Release 15.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information ...

Chapter 5: Solution In the solution phase of an analysis, the computer takes over and solves the simultaneous set of equations t ...

memory parallelism on shared memory parallel hardware (e.g., a desktop or workstation) or distributed memory parallel hardware ( ...

Disk (I/O) Use Ideal Model Memory Use Size Solver Typical Applications chine, 1.0 GB/MDOF 10 GB/MDOF on slave machines In- core: ...

factorization. However, convergence of iterative methods is not guaranteed and the number of iterations required to reach an acc ...

This is essentially equivalent to the optimal out-of-core mode for the non-distributed sparse solver. Therefore, the total memor ...

You can use Table 5.1: Shared Memory Solver Selection Guidelines (p. 112) as a general guideline for memory usage. This solver i ...

The solution time grows linearly with problems size for iterative methods so huge models can still be solved within very reasona ...

symmetric, complex, definite, and indefinite matrices. The QMR solver is more robust than the ICCG solver. 5.3. Solver Memory an ...

Increase the initial memory allocation via -m (for example,-m 24000). This initial memory setting should be larger than what th ...

Learn your memory requirements Use the BCSOPTION command to determine how much memory your job requires (when running the shared ...

Unabridged Solution menus list all solution options, regardless of whether it is recommended, or even possible, for you to use ...

Figure 5.1: Solution Controls Dialog Box The Basic tab, which is shown above, is active when you access the dialog box. The comp ...