On Biomimetics by Lilyana Pramatarova
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 69 61.43.44MPa Our compressive strength result ...
On Biomimetics 70 designed. The grips of the testing setup hold the specimen tightly at the wide ends. The midsection of the sam ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 71 Tensile test of 90/10 dogbone specimen -0.2 ...
On Biomimetics 72 Poisson's ratio measurement 0.38 0.39 0.4 0.41 0.42 0.43 0.44 0.45 PCL 90%PCL-10%CaP 80% PCL-20%CaP Poisson's ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 73 (A) (B) Fig. 17. Designed fixture for tensil ...
On Biomimetics 74 fabricated scaffolds were sterilized with 70% ethanol for 1 hour at room temperature, and washed 3 times with ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 75 the PCL–CaP composite enhances the prolifera ...
On Biomimetics 76 (A) (B) (C) (D) (E) Fig. 21. Bisbenzimide staining of HEPM cells cultured on PCL (Panels A and B) and 80:20 PC ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 77 Biocompatibility has been demonstrated for P ...
On Biomimetics 78 3.1 Introduction of three dimensional printing (3-DP) 3DP was developed at MIT (Massachusetts Institute of Tec ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 79 technique allows the designing and fabricati ...
On Biomimetics 80 (A) (B) (C) (D) (E) (F) Fig. 24. The designed porogens: (A) Square porogen with 200μm struts spaced 800μm apar ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 81 Then the two weighed materials were mixed in ...
On Biomimetics 82 (A) (B) (C) Fig. 27. A: 3-D printed plaster femur head mold; B&C: Front and bottom view of Injected PCL fe ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 83 4.1 Porogen material study-sucrose mixture a ...
On Biomimetics 84 4.2 SFF system design The new SFF system design started with the nozzle jet selection and installation, which ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 85 4.4 Fabrication of scaffolds The designed po ...
On Biomimetics 86 molded PCL scaffold. Figure 30C shows the cells are confluent. Staining for nuclei and cytoskeletal filaments ...
Biomimetic Structured Porogen Freeform Fabrication System for Tissue Engineering 87 (A) (B) Fig. 31. Overlay of bisbenzimide and ...
On Biomimetics 88 composite materials, new SFF system design and integration and system control of the machine has been conducte ...
«
1
2
3
4
5
6
7
8
9
10
»
Free download pdf