Simulink Control Design™ - MathWorks

Enable zero-crossing detection Enable zero-crossing detection to ensure that the software computes the linear system characteris ...

On Compute linear system characteristics at the exact snapshot time or exact time when a trigger signal is detected. This settin ...

Command-Line Information Parameter: UseExactDelayModel Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot L ...

Positive finite value. Use to compute: A discrete-time linear system from a continuous-time system. A discrete-time linear syst ...

Tustin (bilinear) Bilinear (Tustin) approximation without frequency prewarping. The software rounds off fractional time delays t ...

enables Prewarp frequency (rad/s) on page 16-198. Command-Line Information Parameter: RateConversionMethod Type: character vecto ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

Value: 'on' | 'off' Default: 'off' See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verif ...

Command-Line Information Parameter: UseBusSignalLabels Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot L ...

Off Do not check that the gain and phase margins satisfy the specified values, during simulation. Tips Clearing this parameter ...

Tips To assert that the gain margin is satisfied, select both Include gain and phase margins in assertion on page 16-201 and En ...

Tips To assert that the phase margin is satisfied, select both Include gain and phase margins in assertion on page 16-201 and E ...

You can specify multiple closed-loop peak gain bounds on the linear system. The bound also appear on the Nichols plot as an m-ci ...

To only view the closed-loop peak gain on the plot, clear Enable assertion. Command-Line Information Parameter: EnableCLPeakGa ...

You must click Update Block before simulating the model. Command-Line Information Parameter: CLPeakGain Type: character vector V ...

Tips Clearing this parameter disables the gain-phase bound and the software stops checking that the gain and phase satisfy the ...

Positive or negative finite numbers for a single bound with one edge Matrix of positive or negative finite numbers , for a sing ...

Settings Default: [] Must be specified as start and end gains: Positive or negative number for a single bound with one edge Mat ...

Feedback sign Feedback sign to determine the closed-loop gain and phase characteristics of the linear system, computed during si ...

Save data to workspace Save one or more linear systems to perform further linear analysis or control design. The saved data is i ...