RX8--Transmission (Manual & Auto)

Yes Go to the applicable DTC inspection. (See DTC TABLE .) 6 VERIFY AFTER REPAIR PROCEDURE Perform the "After Repair Procedure" ...

AFTER REPAIR PROCEDURE CAUTION: After repairing a malfunction, perform the following procedure to verify that the malfunction h ...

For P0712 Start the engine. Warm up the engine to normal operating temperature. Drive the vehicle in D range for 150 s or more. ...

For P0740 Start the engine. Warm up the engine to normal operating temperature. Drive the vehicle in D range and gradually acce ...

AUTOMATIC TRANSMISSION AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLA ...

1 Front tunnel member 2 Rear tunnel member 3 Heated oxygen sensor connector (w) RX-8 Transmission (Manual & Auto) ...

4 Catalytic converter, middle pipe, main silencer (See EXHAUST SYSTEM REMOVAL/INSTALLATION .) 5 Exhaust manifold stay 6 Manual s ...

(See Transmission Removal Note .) (See Transmission Installation Note .) 26 Stopper 27 Bolt 28 Dynamic dumper 29 Driven plate Ma ...

Power Plant Frame Removal Note Support the transmission using a transmission jack. Remove the power plant frame. Propeller Sha ...

Transmission Removal Note WARNING: Verify that the transmission is securely supported by the jack. If the transmission falls, s ...

Support the transmission securely using a transmission jack. Install the driven plate to the transmission (torque converter), a ...

Tighten nut 1 until the power plant frame is seated in the differential. Install the heat insulator, exhaust manifold stay, cat ...

Bolt, nut number Tightening torque (N·m {kgf·m, ft·lbf}) 1, 2 126.0154.0 {12.915.7, 93.0113.5} 3 74.593.2 {12.9 ...

Tightening torque o 34 49 N·m {3.54.9 kgf·m, 2636 ft·lbf} Tighten the driven plate installation bolts. Tightening torque o ...

AUTOMATIC TRANSMISSION FLUID AUTOMATIC TRANSMISSION FLUID (ATF) INSPECTION Automatic Transmission Fluid (ATF) Condition Inspecti ...

Automatic Transmission Fluid (ATF) Level Inspection CAUTION: The ATF amount varies according to ATF's temperature. Therefore, w ...

While the engine is idling, verify that the ATF level is in the HOT ( 65 °°°°C {149 °°°°F} ) range. Add the specified type of A ...

AUTOMATIC TRANSMISSION SHIFT MECHANISM SHIFT MECHANISM AUTOMATIC TRANSMISSION SHIFT MECHANISM LOCATION INDEX 1 Shift lock (See S ...

(See SELECTOR LEVER INSPECTION .) (See SELECTOR LEVER COMPONENT INSPECTION .) (See SELECTOR LEVER REMOVAL/INSTALLATION .) 5 Stee ...

Verify that the interlock cable moves freely with the brake pedal depressed. If there is any malfunction, replace the interlock ...