RX8--Transmission (Manual & Auto)

Remove the insulator. Mark the manual shaft lever component as shown in the figure. Separate the manual shaft lever component f ...

Remove the manual shaft nut. Remove the washer and manual shaft lever component. Loosen the TR switch mounting bolts. CAUTION: ...

Inspect for continuity between TR switch terminals C and D. Remove the SST. Install the manual shaft lever component and washer ...

Install the manual shaft lever component installation nut. Tightening torque o 10.814.7 N·m {1.11.4 kgf·m, 8.010.8 ft·lbf} ...

(See EXHAUST SYSTEM REMOVAL/INSTALLATION .) Remove the insulator. Disconnect the solenoid valve connector. Measure resistance b ...

ATF temperature (°C {°F}) Resistance (kilohm) −20 {−4} 15.8717.54 0 {32} 5.7276.329 20 {68} 2.3752.625 40 {104} 1.1021.218 6 ...

If there is any malfunction, replace the TFT sensor. (See TRANSMISSION FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION .) ...

Install a new solenoid valve wiring harness (with TFT sensor). Install the oil pan and new gasket to a new oil pan installation ...

Wave pattern Malfunction cause No wave pattern (fixed at HI) Open circuit between turbine sensor terminal (A)TCM terminal 2G O ...

Equipment setting: 5V/DIV (Y): 250 microseconds/DIV (X) Measuring conditions: M range, 1st gear at 20 km/h {12 mph} Verify th ...

(See EXHAUST SYSTEM REMOVAL/INSTALLATION .) Disconnect the turbine sensor connector. Remove the turbine sensor. Apply ATF to a ...

If the actual pattern of the VSS signal is not the same as the reference pattern, inspect and repair the following items: Wave ...

Equipment setting: 5V/DIV (Y): 2.5 ms/DIV (X) Measuring conditions: M range, 1st gear at 20 km/h {12 mph} Verify the wave pat ...

(See EXHAUST SYSTEM REMOVAL/INSTALLATION .) Remove the insulator. Disconnect the TR switch connector. Disconnect the VSS connec ...

o 8 11 N·m {82112 kgf·cm, 7297 in·lbf} Install the catalytic converter. (See EXHAUST SYSTEM REMOVAL/INSTALLATION .) Connec ...

Terminal B and J (oil pressure switch B) Terminal A and J (oil pressure switch C) Terminal L and J (oil pressure switch F)
If ...

If there is continuity, replace the oil pressure switch. (See OIL PRESSURE SWITCH REMOVAL/INSTALLATION .) Install the oil pre ...

Add ATF and, with the engine idling, inspect the ATF level and inspect for leakage. (See AUTOMATIC TRANSMISSION FLUID (ATF) REP ...

AUTOMATIC TRANSMISSION OUTPUT (SOLENOID/INDICATOR LIGHT) SOLENOID VALVE INSPECTION CAUTION: Water or foreign material entering ...

If not within the specification, perform the operating inspection. (See Operating Inspection .) ATF temperature: 20 80 °C {68 ...