Machine Drawing

418 Machine Drawing dharm d:\N-Design\Des21-1.pm5 80 Horizontal 60 20 Continuing 60 Vertical 85 50 Base line dimension Diameter ...

Computer Aided Draughting 419 dharm d:\N-Design\Des21-1.pm5 1. Set-up the basic parameters for dimensioning. They are, (a) arrow ...

420 Machine Drawing dharm d:\N-Design\Des21-1.pm5 accordingly. Dimension line off-setting can also occur with the continue comma ...

Computer Aided Draughting 421 dharm d:\N-Design\Des21-1.pm5 6 150 f 20 9 10 7 120 11 f^60 10 8 80 130 1 2260 3 25 (^1020) 4 75 5 ...

422 Machine Drawing dharm d:\N-Design\Des21-1.pm5 Command: PLINE Front point: 15, 25 (starting point). Once the starting point i ...

Computer Aided Draughting 423 dharm d:\N-Design\Des21-1.pm5 1. Offset distance: a value is to be given 2. Select the object: sel ...

424 Machine Drawing dharm d:\N-Design\Des21-1.pm5 B A Change point Original value Change radius Initial position Command: ELEV N ...

Computer Aided Draughting 425 dharm d:\N-Design\Des21-1.pm5 Extrusion taper angle : by default or choose a value Now, select a s ...

426 Machine Drawing dharm d:\N-Design\Des21-1.pm5 26. Help can be obtained by —————— command. 27. _____ command saves the work. ...

Computer Aided Draughting 427 dharm d:\N-Design\Des21-1.pm5 66. List the various options available for the command DIM. 67. Desc ...

Objective Questions Choose the correct answer or fill in the blanks, for the objective questions given below: CHAPTER 1 1. Produ ...

Objective Questions 429 dharm d:\N-Design\Des22-1.pm5 10. The size of the letters must be constant irrespective of the size of t ...

430 Machine Drawing dharm d:\N-Design\Des22-1.pm5 48. The expansion of U/C is _____. 49. The material abbreviation CS stands for ...

Objective Questions 431 dharm d:\N-Design\Des22-1.pm5 4. In the third angle projection, the object is imagined to be placed ____ ...

432 Machine Drawing dharm d:\N-Design\Des22-1.pm5 2. To obtain full section, of the object is imagined to be removed. (a) One ...

Objective Questions 433 dharm d:\N-Design\Des22-1.pm5 22. The angle of an ACME thread is _____ degrees. (a) 48 (b) 90 (c) 29 (d) ...

434 Machine Drawing dharm d:\N-Design\Des22-1.pm5 7. Sunk keys are used for light duties (True/False). 8. Woodruff key is a type ...

Objective Questions 435 dharm d:\N-Design\Des22-1.pm5 15. Mis-alignment of shafts in compression coupling is taken care of by ...

436 Machine Drawing dharm d:\N-Design\Des22-1.pm5 CHAPTER 9 1. _____ pulley is used to mount at an intermediate location on a sh ...

Objective Questions 437 dharm d:\N-Design\Des22-1.pm5 CHAPTER 11 1. Welding produces a __ joint. (a) Temporary (b)Permanent 2. A ...