Scale Aviation Modeller International - March 2018

YOU NEED THIS MAGAZINE! PAGES! FAST FOX HobbyBoss 1/ MiG-31B Foxhound FOLLY E t r i ch’s Building Wingnut Wings 1/32 Taube FIRST ...

Volks-0318-WP.indd 1 09/02/2018 14: ...

Fw 190A-5 light fighter NEW TOOL http://www.eduard.com 1/ 003-Ads-0318.indd 3 09/02/2018 14: ...

36 Fairey Ultra-light Helicopter AMP 1/72 Fairey Ultra-light Helicopter by Nic Aronica Subscribe see page 50 A s I write this fr ...

manufacturers – earning the name Stahltaube (Steel Dove). This design also introduced a more the wood used by most other tailpla ...

Wingnut Wings 1/32 Jeannin Stahltaube (1914) by PeteR Barker T he original Taube, designed by Austrian Igo Etrich, was based on ...

tailplane – as opposed to the wood used by most other manufacturers – earning the name Stahltaube (Steel Dove). This design also ...

AN ENGINE Not one, in fact, but two! Among the five (or is it seven?) options that WNW offer are aircraft powered by either the ...

decision. Accordingly, for the tubular structure of the fuselage, since it was painted steel, I went for XF-76 Grey Green, as us ...

the preferred method, provided you get it right (and of course you do have the plastic version as a backup, just in case). THE W ...

I gently sanded through to the CDL layer here and there. I then removed the masking tape patches and replaced them with little s ...

cables rigged that can then create enough tension to allow the hooks to work. After that, it’s just a matter of persistence and ...

build was Windsock Datafile 104 The Taube at War, by P M Grosz, which includes three lovely clear photos of A.217/14, as well a ...

MIRAGE T he Dassault Mirage III is arguably one of the greatest combat aircraft in the world, as demonstrated by its longevity, ...

The smaller parts are tidy and require very little cleanup. The weapons sprues are largely irrelevant to this trainer version (d ...

Colour call-outs are for Ammo of MIG only, although there is a conversion table to Vallejo Model Color, GSI Creos Mr. Color, Tam ...

MB Mk4 typical for this application. The plastic for a Mk10 (used on some later versions) is also on the sprues but needs some f ...

The intake ducting is next up. I pre-painted this in aluminium on the inner faces and on the compressor front face. This forked ...

grey” (A MIG-119) quoted for the lower surface. I did a small amount of post highlighting in a random pattern, using H lightened ...

sharp curves are needed. Unusually they proved almost impervious to my usual MicroSol, so I’d suggest something stronger if you ...