Microsoft Word - Woodshop 101 Part 1 of 3

Step 6 We need to drill a hole through the end of the long boards and through the handle. Figure 3 shows the placement of the ho ...

Trajectory-The curved path of an object as it moves from one point to another. Step 7 There’s one more bolt that you should have ...

Step 8 There’s one last thing to do in the construction of the catapult. Using your brace and a 1/8” diameter bit drill a small ...

(1) Wrap a rubber band around the bolt on each side of the tall spacer. (2) Take one end of the rubber band and pull it back thr ...

Planter Box ...

Lesson 21 Planter Box Here’s a simple project to make that’s useful and attractive. It’s also the perfect gift for Mom or Dad to ...

facing to the left and slide them together, (see picture). Also, as you can see from the picture, a chamfer is cut into the edge ...

Step 1 The planter has two panels that are three boards each and two panels that are four boards each. After you slide the board ...

Expand-To grow bigger, to enlarge. Contract-To shrink in size. Step 2 With all the panels cut to size and assembled you’ve proba ...

along the length). So, if we were to screw down the brace board all along the width of each panel, especially two into each boar ...

to drain, water will collect in the bottom with nowhere to go. We need to find a way for the water to drain out. The solution th ...

We found it helpful to have one person hold the bottom section with a couple of clamps holding the panels together while another ...

until the measurements are the same, retighten the clamps and set it aside to dry. Step 7 Now it’s time to attach the top. Earli ...