Microsoft Word - Woodshop 101 Part 1 of 3
Toolbox/Art Caddy......... ...
Things You’ll Need Crosscut jig Measuring tape Handsaw Brace drill 1/8” twist bit 1” auger bit Screwdriver Coping saw (1) 1” x 6 ...
Step 3 Next we need to mark where the holes for the handle will be. You need to mark the center point of the two end pieces whic ...
Step 4 First we’ll look at how we made the design for Katie’s art caddy then Nick’s toolbox. If you’re making the toolbox skip t ...
Symmetrical-Being similar in shape and size with each other For the curves on each side that connects to the top curve we used a ...
The finished drawing of Katie’s art caddy looked like the picture to the right. If yours doesn’t look exactly like this one, don ...
Step 6 After cutting out the shapes on the front and back pieces you may need to smooth the curves out with a rasp. Next, use sa ...
1½”(¾”each side of center point) 3¼” Center point Center point for handle hole Step 8 Set up to cut the angles off the end piece ...
Step 9 Clamp an end piece in a bench vise or clamp it to your workbench with a scrap piece of wood underneath and using a 1” aug ...
Step 11 Lay the bottom and end pieces you just put together on their side. Spread a bead of glue on the edge of the bottom piece ...
Baseball Rack ...
Things You’ll Need Hammer Handsaw Screwdriver Clamps 1 ¼” drywall screws Coping saw Brace 1” and 5/8” auger bits Combination squ ...
Template-Apattern for forming an accurate copy of an object or shape. Step 1 Cut your parts to length by using your measuring ta ...
Step 3 All that’s left on the shelf is to drill a hole for a baseball to rest in. The center point for the hole is 2 ½” over fro ...
Step 4 The dowel to hold your glove is the next piece to add. The center where the dowel will go is located 2 ½” over from the r ...
Step 6 Attaching the shelf is next. With the back piece facing up measure 3” up from the bottom on each side and place a small p ...
Step 8 You can finish your baseball rack however you like. We chose to paint ours using a latex enamel. You can go back to the l ...
Pencil Holder ...
Things You’ll Need Cross cut box Combination square 1” x 6” x 24” (look through your scrap pile or the scrap bin at your lumbery ...
Step 1 Using the measurements above, cut your pieces to size with the crosscut box. As always, label each piece with chalk to av ...
«
1
2
3
4
5
6
7
8
9
10
»
Free download pdf