Microsoft Word - Woodshop 101 Part 1 of 3

securely into a corner of the top. Be sure not to block a pilot hole with one of the clamps, you’ll need to be able to get to th ...

clockwise until they separate. Take the piece that doesn’t have the handle and place it against the long side of the apron. The ...

Doll Cradle ...

Lesson 19 Doll Cradle Here’s a simple project with few parts, that’s fun to build, and will provide hours of entertainment. Now ...

Step 1 Cut all your parts to size according to the cut list. Make sure you label the end pieces and bottom part to avoid confusi ...

Step 2 With one end piece marked with the half circle use your coping saw to cut it out. Remember to stay to the outside of your ...

Step 3 Set the end pieces aside for now and let’s work on the bottom. The first thing we need to do is to find the center across ...

Set your combination square to measure 6 ¾”. Place the head of the square against the bottom of both end pieces and set your pen ...

Takeyourbracebitwitha1”augerbit and drill all the holes. Here’s a hint to keep the drill bit from tearing out the wood as it bre ...

Step 7 Spread a bead of glue on one edge of the bottom piece. With some help line up the center point line on the bottom piece w ...

Before you put the rest of the dowels in, let’s check to make sure that the ends are square to the bottom. Place your speed squa ...

Catapult ...

Things You’ll Need The usual suspects 4d finish nails Brace drill 5/16” bit Screwdriver and 1 ¼” drywall screws (2) 7/16” wrench ...

lumber, the side panels can be cut from a 1 x 6 x 14” board, and all the restcancomefroma1x2x4’board. Rememberthata1x2”isactuall ...

Step 1 Let’s work on the handle first. If you haven’t cut it to size from the cut list yet go on and do that. Next we need to cu ...

Step 3 Next, let’s lay out the holes in the side panels. First thing to do is to place an arrow pointing along the length of eac ...

Step 4 The hex head bolts that we’re using are ¼” size but to make things a little easier when putting things together use a 5/1 ...

Clamp the pieces down to the workbench andwiththesame5/16”bitinyourdrill place the bit in the hole that’s at the bottom corner o ...

Here is how to install the bolts: Take a bolt and slide a washer on, insert the bolt through the holes, place another washer on ...

On the opposite end we need to drill the hole for the catapult arm to pivot on. Use fig. 2 for the placement of the hole. ¾” ½” ...