RX8--Transmission (Manual & Auto)

TRANSMISSION (MANUAL & AUTO) CLUTCH (w) CLUTCH LOCATION INDEX 1 Clutch pipe 2 Clutch fluid 3 Clutch pedal 4 Clutch master cy ...

9 Clutch release collar 10 Pilot bearing 11 Flywheel GENERAL PROCEDURES (CLUTCH) CAUTION: Fluid will damage painted surfaces. B ...

Remove the bleeder cap from the clutch release cylinder, and connect a vinyl hose to the bleeder plug. Place the other end of t ...

CLUTCH PEDAL CLUTCH PEDAL ADJUSTMENT Clutch Pedal Stroke Inspection/Adjustment Measure the clutch pedal stroke. If there is any ...

Standard o Clutch pedal play 5 15 mm {0.200.59 in} o Clutch pedal push rod play At push rod setting line : 0.10.5 mm {0.0040 ...

Clutch disengagement stroke (Reference value) o A: 111.8 mm {4.402 in} Clutch Switch Inspection Remove the engine cover. Remove ...

CLUTCH PEDAL REMOVAL/INSTALLATION Remove in the order indicated in the table. Install in the reverse order of removal. Inspect ...

14 Clutch pedal component Starter Interlock Switch Installation Note CAUTION: If the rod is pushed in, it may not operate prope ...

CLUTCH MASTER CYLINDER CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION CAUTION: Fluid will damage painted surfaces. Be careful not ...

CLUTCH MASTER CYLINDER DISASSEMBLY/ASSEMBLY Disassemble in the order indicated in the table. Assemble in the reverse order of d ...

14 Clutch master cylinder body Snap Ring Disassembly/Assembly Note While pressing the piston in with a cloth-wrapped pin punch ...

CLUTCH RELEASE CYLINDER CLUTCH RELEASE CYLINDER REMOVAL/INSTALLATION CAUTION: Fluid will damage painted surfaces. Be careful no ...

3 Clutch pipe 4 Bolt 5 Clutch release cylinder CLUTCH RELEASE CYLINDER DISASSEMBLY/ASSEMBLY Disassemble in the order indicated ...

CLUTCH UNIT CLUTCH UNIT REMOVAL/INSTALLATION Remove in the order indicated in the table. Install in the reverse order of remova ...

8 Oil seal 9 Pilot bearing 10 Locknut 11 Flywheel Clutch Cover, Clutch Disc Removal Note Install the SSTs. In criss-cross patte ...

NOTE: Inspect the eccentric shaft for oil leakage after removing the flywheel. If necessary, replace the oil seal. Remove the ...

Tighten the locknut using the SST. Tightening torque o 392 490 N·m {40.049.9 kgf·m, 289361 ft·lbf} CAUTION: Remove the sea ...

11.512.25 mm {0.4530.482 in} Install a new oil seal using the SSTs. Clutch Disc Installation Note Clean the splines o ...

CLUTCH COVER CLUTCH COVER INSPECTION Remove the clutch cover. Measure the wear of the diaphragm spring fingers using a vernier ...

Maximum height difference o 1.0 mm {0.039 in} If it exceeds the maximum specification, replace the clutch cover. CLUTCH DISC C ...