RX8--Transmission (Manual & Auto)

NO.7 NO CREEP AT ALL 7 No creep at all DESCRIPTION Vehicle does not move in D range and R position when idling on flat paved ro ...

Yes Go to the next step. 2 Disconnect the TCM connector. Is the resistance between terminal 2U at the TCM connector and terminal ...

NO.8 LOW MAXIMUM SPEED AND POOR ACCELERATION 8 Low maximum speed and poor acceleration DESCRIPTION Vehicle acceleration is poor ...

are conducted. (See BASIC INSPECTION .) Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 With the ignition ...

Is the resistance between terminal 2U at the TCM connector and terminal J at solenoid valve wiring harness-side connector 5.0 oh ...

NO.9 NO SHIFTING 9 No shifting DESCRIPTION Single shift range only. Sometimes shifts correctly. POSSIBLE CAUSE Clutch slippag ...

Yes Go to the next step. 1 With the ignition switch at the ON position, does the gear position indicator light indication corres ...

Disconnect the solenoid valve connector. Measure the resistance between the following solenoid valve connector terminals. (See S ...

NO.10 DOES NOT SHIFT TO 4GR 10 Does not shift to 4GR DESCRIPTION Vehicle does not upshift from 3GR to 4GR even though vehicle s ...

Disconnect the solenoid valve connector. Measure the resistance between terminals E and J at solenoid valve connector. (See SOLE ...

NO.11 ABNORMAL SHIFTING 11 Abnormal shifting DESCRIPTION Shifts incorrectly (incorrect shift pattern). POSSIBLE CAUSE Imprope ...

Does the vehicle operate as follows? D range: 3GR (fixed) R position: Reverse No Overhaul the control valve body and repair or r ...

7 Remove the torque converter. Inspect the torque converter. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION .) (See AUTOMATIC ...

NO.12 FREQUENT SHIFTING 12 Frequent shifting DESCRIPTION Downshifting occurs suddenly even when accelerator pedal is depressed ...

NO.13 SHIFT POINT IS HIGH OR LOW 13 Shift point is high or low DESCRIPTION Shift point is considerably different from automatic ...

NO.14 TORQUE CONVERTER CLUTCH (TCC) NON-OPERATION 14 Torque converter clutch (TCC) non-operation DESCRIPTION TCC does not opera ...

(See PCM INSPECTION .) (See TCM INSPECTION .) o PCM PIDs (using WDS or equivalent): APP1 APP2 TP_REL VSS o TCM terminal voltag ...

6 Remove the torque converter. Inspect the torque converter. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION .) (See AUTOMATIC ...

NO.15 NO KICKDOWN 15 No kickdown DESCRIPTION Does not downshift when accelerator pedal is fully depressed within kickdown range ...

NO.16 ENGINE FLARES UP OR SLIPS WHEN UPSHIFTING OR DOWNSHIFTING 16 Engine flares up or slips when upshifting or downshifting DES ...