RX8--Transmission (Manual & Auto)

Inspect for continuity between the selector lever (wiring harness-side) and body ground.
M range switch position: terminal B ...

DTC P0708 DTC P0708 Steering shift switch circuit malfunction (open circuit/short to ground) DETECTION CONDITION Signal from st ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

Yes Go to the next step. 4 INSPECT CLOCK SPRING GROUND CIRCUIT FOR OPEN CIRCUIT Inspect for continuity between the clock spring ...

Yes Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION .) 10 VERIFY TROUBLESHOOTING OF DTC P0708 COMPLETED ...

DTC P0711 DTC P0711 Transmission fluid temperature (TFT) sensor malfunction (stuck) DETECTION CONDITION ATF temperature remains ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

Turn the ignition switch to the LOCK position. Inspect the TFT sensor. (See TRANSMISSION FLUID TEMPERATURE (TFT) SENSOR INSPEC ...

DTC P0712 DTC P0712 Transmission fluid temperature (TFT) sensor circuit malfunction (short to ground) DETECTION CONDITION Signa ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

INSPECT CONTROL VALVE BODY CONNECTOR TERMINALS CONDITION Turn the ignition switch to the LOCK position. Disconnect the control ...

DTC P0713 DTC P0713 Transmission fluid temperature (TFT) sensor circuit malfunction (open circuit/short to power supply) DETECTI ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

Yes Go to the next step. 4 INSPECT TCM CONNECTOR FOR POOR CONNECTION Turn the ignition switch to the LOCK position. Inspect for ...

INSPECT CONTROL VALVE BODY CONNECTOR FOR POOR CONNECTION Disconnect the control valve body connector. Inspect for poor connecti ...

Make sure to reconnect all disconnected connectors. Clear the DTC from the TCM memory using the WDS or equivalent. Drive the ve ...

DTC P0715 DTC P0715 Turbine sensor circuit malfunction DETECTION CONDITION The following condition is detected twice:
Turbine ...

Diagnostic procedure STEP INSPECTION ACTION Yes Go to the next step. 1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FR ...

INSPECT TURBINE SENSOR POWER SUPPLY CIRCUIT FOR OPEN CIRCUIT Turn the ignition switch to the ON position (engine off). Inspect ...

Inspect the turbine sensor. (See TURBINE SENSOR INSPECTION .) Is the turbine sensor normal? No Replace the turbine sensor, t ...